Sharp AL-1020 Service Manual

Also see for AL-1020: Operation manual

Contents

Main code Sub code Contents26 43 Side void amount setting(Operation/Procedure)1. When this simulation is executed, the currently set code number of the side void amount isdisplayed.2. Enter the code number and press the start key. The setting is changed.44 SPF document rear edge detection setting (Used to erase the document rear edge shadegenerated in SPF reduction copy.)When this simulation is executed, the currently set code number is displayed. Enter the desiredcode number and press the START key, and the display will be changed. The document rearedge scanning area in SPF reduction (less than 100%) copy is changed.The code number is changeable in the range of 0 - 8.The default value is 4, and 2 mm of the document rear edge is cut.When the value is changed by 1, the area is changed by 1 mm.50 1 Lead edge image position and paper lead edge/rear edge void adjustment(Outline)This adjustment is used to adjust the copy image position and lead edge/rear edge void amounton the copy paper by adjusting the image scan start position and the print start position (resistroller ON timing) at 100%.(Operation/Procedure)1. When this simulation is executed, the currently set value is displayed in two digits. (Centervalue: 50)2. When the copy mode select key is pressed, each setting mode and the display are changed.∗ The selected adjustment mode is indicated by the lamps as shown in the table below.3. Enter the adjustment value with the 10-key and press the start key. The set value is storedand a copy is made. (When the set value is increased by 1, the void amount is shifted by 0.1mm.)4. When the clear key is pressed, the set value is stored and the simulation mode is terminated.Code number Setting0 0 mm1 0.5 mm2 1.0 mm3 1.5 mm4 2.0 mm * Default5 2.5 mm6 3.0 mm7 3.5 mm8 4.0 mm9 4.5 mm10 5.0 mmAdjustment mode Display lampPrint start position AE lampImage lead edge void amount TEXT lampImage scan start position (Scanner) PHOTO lampImage rear edge void amount AE, TEXT, PHOTO lampSPF image scan start position AE, TEXT lampAL-12507-2