Sharp 00ZSF1116/A1E Service Manual

5. Details of simulationsSimulation input procedure: C → ë → 0 → ëMain code Sub code Content01 01 Mirror operation checkWhen the print button is pressed, the mirror is scanned at a speed corresponding to the currently set copymagnification ratio.The copy magnification ratio can be arbitrarily set.02 Optical system sensors (MHPS, LHPS) state displayON/OFF state of the optical system sensor can be monitored by the LED on the operation panel.Sensor name Operation panel LEDMHPS Paper empty lamp (ç)LHPS JAM lamp (ê)03 Lens operation checkThe lens unit moves to the following positions of the magnification ratios continuously.AB series: 100% → 115% → 122% → 141% → 200% → 86% → 81% → 70% → 50% → 100%Inch series: 100% → 121% → 129% → 141% → 200% → 95% → 77% → 64% → 50% → 100%04 Lens agingThe operation of SIM 1-3 is repeated continuously.02 01 ADF agingThe ADF original transport operation is performed.02 ADF sensors states displayThe ADF sensors ON/OFF states can be monitored with the LED on the operation panel.When the third digit of the multi display is “0” the following display is made.Sensor name Operation panel LEDOriginal set sensor JAM lamp (ê)Resist sensor Paper empty sensor (ç)Timing sensor Drum position jam lamp (t)Repulsion sensor Resist position jam lamp (t)ADF open/close sensor ADF position jam lamp (t)Paper feed cover sensor Paper exit position jam lamp (t)If, at that time, the magnification ratio display key is pressed, the third digit of the multi display is changed to “1”and the following display is made.Sensor name Operation panel LEDTray width sensor (297mm, 11") First step paper size lampTray width sensor (257mm) Second step paper size lampTray width sensor (210mm, 8.5") Third step paper size lampTray width sensor (182mm) Fourth step paper size lampTray vertical sensor (240mm) Resist position jam lamp (t)Tray vertical sensor (300mm) Paper exit position jam lamp (t)Original width size sensor Manual feed selection lamp03 ADF individual load operation check (paper feed motor forward rotation)04 ADF individual load operation check (paper feed motor reverse rotation)05 ADF individual load operation check (transport motor forward rotation)06 ADF individual load operation check (transport motor reverse rotation)08 ADF individual load operation check (Paper feed solenoid)10 ADF individual load operation check (paper feed motor + paper feed solenoid)8 – 3