Sharp 00ZSF1116/A1E Service Manual

9. Center shift adjustmentThere is basically no need to perform the center shift adjustmentbecause it is made when shipping. If the center should be shifted,adjust in the following procedures.Make a copy. If the center is shifted as shown in Fig. 1 or Fig. 2,loosen the four screws which are fixing the cassette grip cabinet.(Note) When fixing the cassette cabinet, the fixing screws and thecabinet clearance a and b are in symmetry.(1) Fig. 1Move the cassette grip cabinet in direction A, tighten two fixingscrews (a) and tow fixing screws (b) in this sequence. Make a copyagain and check the center.(2) Fig. 2Move the cassette grip cabinet in direction B, tighten two fixingscrews (a) and tow fixing screws (b) in this sequence. Make a copyagain and check the center.10. Label attachmentA. Label attachmentAttach the magnification ratio select label packed together with theOperation manual to the position shown in the figure below.• When attaching the label to the copier with the original cover.• When attaching the label to the optional automatic original feeder(SF-A18)Section a Direction A Section aDirection BSection b Section b[Reference figure]Section bSection a[Fig.1] Paper center lineImage center line (First image)[Fig.2] Paper center lineImage center line (First image)Magnification ratio select lableMagnification ratio select lable4 – 7