Sealey SV20 Series Quick Start Manual

Also see for SV20 Series: Manual Quick start guide Manual Manual Quick start guide

20V SV20 SERIES CORDLESS STRIMMER -BODY ONLYMODEL NO: CS20VThank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY9 Always wear appropriate eye protection, ear protection, substantial footwear, gloves, long trouserswhilst operating.9 Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain longhair.9 Inspect and ensure equipment is in good working order before use.9 Maintain and clean tool and battery pack, regularly. Check air holes are clear.9 Must be serviced by an authorised agent. Use genuine parts only. Non authorised parts willinvalidate the warranty. WARNING! Remove battery before: performing maintenance, carrying out adjustments,inspecting the machine after striking an object, before clearing a blockage, before leaving the toolunattended, before moving to the next job location.9 WARNING! Risk assess the work area. Keep bystanders away from the work area.8 DO NOT operate with anyone or pets nearby. Check intended work area for wildlife.8 DO NOT use in bad weather conditions, especially when there is a risk of lightning. DO NOTexpose to rain. Only use in good light.8 DO NOT use if tool vibrates abnormally, switch off, remove battery and then inspect.8 DO NOT touch hazardous moving parts. Allow to come to a complete stop first.8 DO NOT operate whilst tired, ill under the influence of alcohol or other intoxicating drugs.8 DO NOT overreach and keep balance at all times.8 DO NOT use if damaged. DO NOT operate with defective guards or shields or without safety device.8 DO NOT use for a task it was not designed to perform.9 Store with the battery removed and separate from the machine, in a dry, childproof location. WARNING! Never allow children, persons with reduced physical sensory or mental capabilities or lack of experience and knowledge orpeople unfamiliar with these instructions to use the machine, local regulations may restrict the age of the operator.1.1. HAND ARM VIBRATION WARNING! – RISK OF HAND ARM VIBRATION INJURYThis tool may cause Hand Arm Vibration Syndrome if its use is not managed adequately.This tool is subject to the vibration testing section of the Machinery Directive 2006/42/EC.This tool is to be operated in accordance with these instructions.Measured vibration emission value (a): 5.8/s²Uncertainty value (k): 2.3m/s²Please note that the application of the tool to a sole specialist task may produce a different average vibration emission. We recommendthat a specific evaluation of the vibration emission is conducted prior to commencing with a specialist task. A health and safetyassessment by the user (or employer) will need to be carried out to determine the suitable duration of use for each tool.NB: Stated Vibration Emission values are type-test values and are intended to be typical.Whilst in use, the actual value will vary considerably from and depend on many factors.Such factors include; the operator, the task and the inserted tool or consumable.NB: ensure that the length of leader hoses is sufficient to allow unrestricted use, as this also helps to reduce vibration.The state of maintenance of the tool itself is also an important factor, a poorly maintained tool will also increase the risk of Hand ArmVibration Syndrome.1.2. HEALTH SURVEILLANCEWe recommend a programme of health surveillance to detect early symptoms of vibration injury so that management procedures canbe modified accordingly.1.3. PERSONAL PROTECTIVE EQUIPMENTWe are not aware of any personal protective equipment (PPE) that provides protection against vibration injury that may result from theUncontrolled use of this tool. We recommend a sufficient supply of clothing (including gloves) to enable the operator to remain warmand dry and maintain good blood circulation in fingers etc. Please note that the most effective protection is prevention, please referto the correct use and maintenance section in these instructions. Guidance relating to the management of hand arm vibration can befound on the HSE website www.hse.gov.uk - Hand-Arm Vibration at Work.Refer toinstructionsWear eyeprotectionWear protectiveglovesWear earprotectionWear safetyfootwearWear protectiveclothingKeep in dry areaprotect from rainOriginal Language Version© Jack Sealey Limited CS20V Issue 3 (H,1,3,F) 04/10/23

/ 3

Related manuals for Sealey SV20 Series