Sealey RE229.V3 Instructions Manual

instructions forprofessional coil spring compressor set2500kgmodel no: re229.V3thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. safetyV Danger! Stop compressing the spring before the coil windings touch, fig.2.A. Exercise particular caution when using an air impactwrench.R Warning! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using thisequipment.R Warning! Wear approved safety eye protection (standard spectacles are not adequate).R Warning! Do not compress the spring to an extent where the jaws touch, fig.2.B. Do not operate spring compressor if parts are damaged or missing as this may cause failure and/or personal injury. Do not force the spring compressor to achieve a task it was not designed to perform. Do not allow untrained persons to use the spring compressor. Familiarise yourself with the applications, limitations and potential hazards of the spring compressor. Maintain the spring compressor in good condition. Replace or repair damaged parts. Use genuine parts only. Unauthorised parts maybe dangerous and will invalidate the warranty. Keep the work area clean, uncluttered and ensure there is adequate lighting. Keep hands and body clear of the spring when operating the spring compressor. Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes. Remove ill fitting clothes. Remove ties, watches, rings, other loose jewellery. Contain and/or tie back long hair. Wear appropriate protective clothing. When not in use, clean and store the spring compressor in a safe, dry, childproof location.2. introDuctionsuitable for MacPherson strut coil springs. Features a yoke extension bracket that also allows use on conical springs. Supplied with threepairs of different sized interchangeable yokes, for a wide range of vehicle applications and plastic yoke protectors that protect the springcoating from damage which can invalidate the vehicle manufacturer’s warranty. Safety yokes carefully shaped to stop the spring bowing whileunder compression.3. specificationmodel no: ..............................................................re229.V3capacity: .................................................................... 2500kgYoke Specification (Size/Suitability): ......................................Gold Yokes: ........................................................ Ø80-105mmBlack Yokes: ........................................................ 105-140mmsilver Yokes: .................................................... Ø145-190mmmaximum jaw opening:............................................... 265mmdrive: .................................................................... 21mm hex4. Descriptionrefer to fig.14.1 The compressor consists of a solid steel body mounted with two forgedjaw interlocks, one on the body and the other on a centrally mounted spindle.1 Retaining bolts 5 Spring2 Yoke 6 Safety clips3 Compressor body 7 Outer rib4 Hex nutrE299.V3 | Issue 2(I) 23/09/15Original Language Version© Jack Sealey Limitedrefer toinstructionmanualwear eyeProtectionfig.1

/ 3

Related manuals for Sealey RE229.V3