Sealey RE2280 Instructions Manual

Also see for RE2280: Instructions

INSTRUCTIONS FORCOIL SprIng COmpreSSOrmODEL: RE2280Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions andproperly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGSAND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TODO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONSSAFE FOR FUTURE USE. DANGER! Stop compressing the spring before the coilwindings touch. WARNING! Ensure Health & Safety, local authority,and general workshop practice regulations are adheredto when using this equipment. WARNING! Wear approved safety eye protection(standard spectacles are not adequate). WARNING! Measure the outer diameter of the springto be compressed and select the correct set of jaws tofit the spring. DO NOT operate spring compressor if parts aredamaged or missing as this may cause failure and/orpersonal injury. DO NOT force the spring compressor to achieve a taskit is not designed to perform. DO NOT allow untrained persons to use the springcompressor. Familiarise yourself with the applications, limitationsand potential hazards of the spring compressor. Maintain the spring compressor in good condition.Replace or repair damaged parts. Use genuine partsonly. Unauthorised parts may be dangerous and willinvalidate the warranty. Keep the work area clean, uncluttered and ensurethere is adequate lighting. Keep hands and body clear of the spring whenoperating the spring compressor. Maintain correct balance and footing. Ensure the floor isnot slippery and wear non-slip shoes. Remove ill fitting clothes. Remove ties, watches, rings,other loose jewellery. Contain and/or tie back long hair. Wear appropriate protective clothing. When not in use clean and store the spring compressorin a safe, dry, childproof location.2. TeCHnICAL SpeCIFICATIOn1. SAFeTY InSTrUCTIOnSMaximum Spring Load: ...................................1250kgSize/Suitability: ............................. (Ø80mm - 135mm)Jaw Opening: ...........................................115-300mmDrive: ......................................................... 19mm Hex3. InTrODUCTIOn3.1. Designed for use on wishbone suspension usingaccess points in the rear suspension arm.Features two pairs of carefully shaped yokes thatprevent the coil spring from bowing.Saves time over traditional methods of demountingsprings.Fig.1Original Language Version RE2280 Issue: 1 - 7/6/10

/ 2

Related manuals for Sealey RE2280