Sealey HBS97.V2 Manual

Also see for HBS97: Instructions

UNIVERSAL HEADLAMP BEAM SETTERModel no: HBS97.V2Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAfETy8 DO NOT allow unqualified persons to operate this device.8 DO NOT use this device in direct sunlight.8 DO NOT splash the unit with water or any other liquid.9 do ensure the work area is well ventilated.9 do ensure that there is good lighting9 do put the handbrake on.9 do avoid sudden changes in temperature.9 do avoid sudden vibration.2. INTRODUcTIONMoT Approved for use in testing stations for vehicle Classes I, II, III and IV. Purchase Model no. HBS97e extension Rails and the unit issuitable for Classes V, VI and VII. For commercial testing purchase Model No. HBS97.HGV. Supplied with instructions and certificate ofapproval (MoT versions with rails).3. SPEcIfIcATIONModel no: ...................................................................HBS97Height: ..................................................................... 1750mmlength: ....................................................................... 690mmMax. Height Beam Measurement: ............................ 1410mmMin. Height Beam Measurement: ............................... 240mmnett Weight: ................................................................... 43kgRail length: .............................................................. 2970mmWidth:......................................................................... 660mmHBS97e ...........................................1520mm extension RailHBS97eS .......................................... 700mm extension Rail4. ASSEMBLy4.1. Place large metal washer over spigot at base of column B.4.2. Insert column spigot into bearing in base A and retain with socket cap boltand washer provided.4.3. Attach mirror-visor d to the rotating metal friction plate at the top of thecolumn using the two socket cap bolts provided.4.4. Fit the optical system e to the vertical - sliding system using an M8 bolt inboth the top and bottom holes.4.5. If the unit is to run on rails these need to be fixed to the floor of the testbay with low profile fixings that will not interfere with the movement of thewheels.4.6. To ascertain the correct positions for the rails place a typical vehicle inthe test bay and follow the test procedure without rails. When the unit iscorrectly positioned for one headlamp mark the wheel positions on the floor including a longitudinal centre line. Roll the unit overto the other headlamp, check the alignment, and mark the floor again.4.7. Place the rails loose on the floor using the markings made and put the unit on them. Roll the unit from one lamp to the other andrecheck the alignment. When satisfied that all is correct fix the rails to the floor.4.8. HBS97.V2 is approved for class I,II,III and IV as delivered, and by purchasing HBS97e Rail extensions the unit is also suitable forClass V, VI,VII. For testing classes I, II, III and IV the rails may be surface mounted. We recommend the rails be recessed into the floorfor all other vehicle testing classes.A BASEB cOLUMNc VERTIcAL SLIDING SySTEMD MIRROR-VISORE OPTIcAL SySTEMf cOLUMN LOcK PEDALHBS97.V2 Issue 3 (HF) 16/08/18Original Language Version© Jack Sealey limitedRefer toinstructionsfig.1For indoor useonly

/ 5

Related manuals for Sealey HBS97