Sealey HBS97 Instructions Manual

Also see for HBS97: Manual

The SEALEY HEADLAMP BEAM SETTER, HBS971, is supplied with a rotating column, mirror and visor. The HBS97, has the addition of a railset. The HEADLAMP BEAM SETTER or (HBS), may be used for checking headlights on Cars, Heavy goods vehicles and Motorcycles.SPECIFICATIONS: Height 1520/1770mm Maximum height of beam measurement 1410mmWidth 610mm Minimum height of beam measurement 240mmLength 610mm Focal Length 500mmA BASEB COLUMNC VERTICAL SLIDING SYSTEMD MIRROR-VISORE OPTICAL SYSTEMF SPRING PROTECTIONH WHEELSL LEVELLING BOLTM VISOR LOCKING WHEELN BRAKE2. 1. Insert column B into base A.2. 2. insert the mirror-visor D in the hole at the top of column B.2. 3. In the upper hole insert visor locking wheel M.2. 4. Fit the optical system E to the vertical - sliding system using an M8bolt in the top hole and levelling bolt L in the bottom.HBS97HBS971- 165 - 2404981. DESCRIPTION2. ASSEMBLING THE HBS9713. WORKING SURFACE3. 1. Position the vehicle on the designated headlamp aim standing area.3. 2. When positioning the HBS ensure the floor is perfectly even and level.3. 3. If this is not possible the vehicle and HBS must be on the same slope, which must not exceed 0.5º.3. 4. Headlights must not be checked where surfaces exceed 0.5º angle. (See fig 3A.).OKfig 3A. NO NO0.50 MAXGENERAL RULESRead instruction manual carefully before using the headlight beam tester.TO AVOID DAMAGE ENSURE THE FOLLOWING IS STRICTLY APPLIED.DO NOT allow unqualified persons to operate this device.DO NOT use this device in direct sunlight.DO NOT splash the unit with water or any other liquid.DO ensure the work area is well ventilated.DO ensure that there is good lightingDO put the handbrake on.DO avoid sudden changes in temperature.DO avoid sudden vibration.INSTRUCTIONS FOR:UNIVERSAL HEADLAMP BEAM SETTERModels: HBS97 & HBS971Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructionsand properly maintained, give you years of trouble free performance.(The use of symbols in this manual is to attract your attention to possible danger, and reminders, the symbols and warnings themselves do not eliminate any danger, nor are theysubstitutes for proper accident prevention measures).4. 1. Straighten vehicle wheels.4. 2. Check the tyre pressure.4. 3. Ensure the headlights are clean and dry.4. 4. If the vehicle is fitted with manual or electric headlamp levelling devices, ensure these are set up for vehicle with normal load.4. 5. Remove anything which could alter the vehicles position, i.e. Snow, Ice, Mud, etc.4. VEHICLE PREPARATIONIMPORTANTPLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSEDAMAGE OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

/ 4

Related manuals for Sealey HBS97