Sealey ECS300.V2 Manual

ELECTRONIC STARTER/CHARGER/MAINTAINER300/45A 12/24VMODEL NO: ECS300.V2Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY1.1. ELECTRICAL SAFETY WARNING! It is the responsibility of the owner and the operator to read, understand and comply with the following:9 Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs andall electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electricalproducts.Electrical safety information. It is important that the following information is read and understood:9 Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.9 Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.Important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with thecorrect fuse.8 DO NOT pull or carry the appliance by the power cable.8 DO NOT pull the plug from the socket by the cable.8 DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or is replaced immediately by aqualified electrician.If the cable or plug is damaged during use, switch off the electricity supply and remove from use.Ensure that repairs are carried out by a qualified electrician.1.2. BATTERY CHARGER SAFETY INSTRUCTIONS9 Familiarise yourself with the applications, limitations and potential hazards relating to the starter/charger. Also refer to the vehiclemanufacturer’s handbook. IF IN ANY DOUBT CONSULT A QUALIFIED ELECTRICIAN.9 Ensure the starter/charger is in good order and condition before use. If in any doubt, do not use the unit and contact an electrician.9 Only use genuine parts. To use unapproved parts may be dangerous and will invalidate your warranty.9 Use the starter/charger in the horizontal position only and ensure it stands on a stable surface which will adequately support the weight.9 Ensure the charger is switched off and disconnected from the mains power supply before attaching the power clamps to the battery.9 Keep tools and other items away from the engine and ensure that you can see the battery and working parts of the engine clearly.9 If the battery has removable caps to access the battery fluid, remove the caps and check the fluid level before connecting the powerleads.If necessary top-up the battery with distilled water by referring to the battery manufacturer’s instructions, (apply the personal safetyprecautions described in para. 1.2.).8 DO NOT dis-assemble the starter/charger for any reason. It must be checked by qualified service personnel only.9 The cables may become hot with excessive use. If so, allow a few minutes for them to cool down before attempting to re-use.9 If the starter/charger receives a sharp knock or blow, the unit must be checked by a qualified service agent before using.9 When not in use, store the starter/charger carefully in a safe, dry, childproof location.9 Ensure the positive cable is connected to the correct voltage connection on the charger as for the voltage of the battery being charged.9 Keep children and unauthorised persons away from the work area.8 DO NOT try to charge a non-rechargeable battery.8 DO NOT try to start with a frozen battery. DO NOT attempt to charge a frozen battery. WARNING! DO NOT allow metal tools to touch both battery terminals at the same time. The resulting spark or short circuit may causean explosion.8 DO NOT pull the cables or clamps from the battery terminals.8 DO NOT use this product to perform a task for which it is not designed.ECS300.V2 Issue 2 (2) 15/01/24Original Language Version© Jack Sealey LimitedRefer toinstructionsElectricalshockhazardWear eyeprotectionWear protectiveglovesWarningcorrosivesubstanceWarning:explosiveKeep awayfrom sources ofignitionUse in wellventilated areasKeep in dry areaprotect from rain