Sealey AK438.V2 Instructions Manual

Also see for AK438.V2: Instructions

3.1. CHANGING THE BULB WARNING! Ensure the spotlight is turned off and the lens has cooledprior to changing the bulb.1. Remove the hood from the spotlight.2. Carefully lift the hood and reflector assembly revealing thespring clip (fig. 6.1.) and three wires.3. Disconnect the three wires (fig. 6.2.). Make a note which wiresconnect to which terminal.4. Remove the spring clip (fig. 6.1.).5. Pull bulb (fig.6.3) outward from the reflector.6. Hold the new bulb with a lint free cloth, (do not handle the bulb),and install by reversing the above procedure.3.2. CHANGING THE BATTERY WARNING! Ensure you read, understand and apply safetyinstructions relating to the battery before changing.1. Remove the rear rubber seal by way of the polymer knobs eitherside (fig. 1B). Unscrew them counter clockwise.2. Remove battery braces with phillips screwdriver.3. Securely grip the exposed end of the battery and carefully slide it afew inches out of the housing (fig. 8).4. Disconnect the battery terminal wires. Remove the black negativewire first. WARNING! Beware of causing a short circuit.5. Carefully remove the battery.6. Replace with genuine Sealey battery and install by reversing theabove procedure.Notes: a) Take care not to pinch or cross-connect any wires.b) When replacing rear rubber seal make sure thatboth knobs are secure.7. Dispose of old batteries in accordancewith local authority lead-acid batteryregulations. DO NOT dispose of withregular refuse.INSTRUCTIONS FOR:RECHARGEABLE SPOTLIGHT10,000,000 CANDLE POWERMODEL No: AK438.V2Thank you for purchasing a Sealey Product. Manufactured to a high standard this productwill, if used according to these instructions and properly maintained, give you years oftrouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTETHE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSEFOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGEAND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY INSTRUCTIONS1.1. GENERAL Ensure the spotlight is correctly charged before initial use. When fully charged and on full beam, the spotlight must not be used formore than 15 minutes of continuous use. To do so may damage thelamp. WARNING! The lens becomes very hot during operation. DO NOT cover or block the lens during use. DO NOT turn the spotlight on when it is being re-charged. DO NOT shine directly into your, other person’s or animal’s eyes. DO NOT stand the spotlight near any surface or item that may beadversely effected by the heat emitted from the lens. DO NOT allow children to use the spotlight. DO NOT handle or move the spotlight whilst it is being charged. DO NOT use the spotlight if you suspect that the battery or the spotlightcasing is damaged. DO NOT handle spotlight bulb with your fingers. Use a soft lint-free cloth. Ensure that genuine and correctly rated battery and bulb are used forreplacements. When not in use store the spotlight in a safe, dry, childproof location.Sole UK Distributor, Sealey Group, KempsonWay, Suffolk Business Park, Bury St. Edmunds,Suffolk, IP32 7AR01284 757500 01284 703534NOTE: It is our policy to continually improve products and as such we reserve the right toalter data, specifications and component parts without prior notice.IMPORTANT: Noliability is accepted for incorrect use of this equipment. WARRANTY: Guarantee is 12months from purchase date, proof of which will be required for any claim. INFORMATION:For a copy of our latest catalogue and promotions call us on 01284 757525 and leave yourfull name and address, including postcode.1.2. BATTERY SAFETYDANGER! - BE AWARE, LEAD-ACID BATTERIES MAY BE DANGEROUSIF NOT HANDLED WITH CARE AND ACCORDING TO THESEINSTRUCTIONS., Before exposing the battery for replacement, remove personal metallicitems such as rings, bracelets, necklaces and watches. A lead-acidbattery can produce a short-circuit current high enough to weld a ringto metal, which would cause severe burns. DO NOT smoke or allow a spark or flame in the vicinity of the battery. Ensure the charger is switched off and disconnected from the spotlightbefore attempting to open the lamp unit. If the battery wire terminals are corroded or dirty, clean them beforereplacing battery. DO NOT dis-assemble the battery for any reason. WARNING! DO NOT allow metal tools to touch both battery terminalssimultaneously. Arcing or short circuit will result. DO NOT allow battery wires to touch each other or to make contactwith any other metallic part. DO NOT cross-connect wires to the battery as this will damage the unit.Ensure positive (+) (RED) is to positive and negative (-) BLACK is tonegative. DO NOT leave battery in a discharged state, recharge batteryimmediately. If the spotlight is not in use, recharge the battery every three months. Dispose of the old battery in accordance with local authority acid batteryregulations. DO NOT dispose of with regular refuse.3. MAINTENANCEsales@sealey.co.uk www.sealey.co.uke-mail W e bfig.8fig.7Environmental Protection.Recycle unwanted materials instead of disposing of them as waste. All tools,accessories and packaging should be sorted, taken to a recycle centre anddisposed of in a manner which is compatible with the environment.When the product is no longer required, it must be disposed of inan environmentally protective way.fig.6Original Language Version AK438.V2 Issue: 4(I) - 13/12/13 Original Language Version AK438.V2 Issue: 4(I) - 13/12/13© Jack Sealey Limited © Jack Sealey Limited

/ 2

Related manuals for Sealey AK438.V2