Sealey AK436.V2 Instructions Manual

INSTRUCTIONS FOR:RECHARGEABLE SPOTLIGHT3,000,000 CANDLE POWERModel: AK436.V2Thank you for purchasing a Sealey Product. Manufactured to a high standard this productwill, if used according to these instructions and properly maintained, give you years oftrouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTETHE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSEFOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGEAND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY INSTRUCTIONS1.1. GENERAL Ensure the spotlight is correctly charged before initial use. When fully charged, spotlight must not be used continuously for morethan 20 minutes. To do so may damage the spotlight. WARNING! The lens becomes very hot during operation. DO NOT cover or block the lens during use. DO NOT turn the spotlight on when it is being re-charged. DO NOT shine directly into your, other person’s or animal’s eyes. DO NOT stand the spotlight near any surface or item that may beadversely effected by the heat emitted by the lens. DO NOT allow children to use the spotlight. DO NOT handle or move the spotlight whilst it is being charged. DO NOT use the spotlight if you suspect that the battery or thespotlight casing is damaged. DO NOT handle the bulb with your fingers. Use a soft lint-free cloth. Ensure that correctly rated battery and bulb are used for replacements. When not in use store the spotlight in a safe, dry, childproof location.NOTE: It is our policy to continually improve products and as such we reservethe right to alter data, specifications and component parts without prior notice.IMPORTANT: No liability is accepted for incorrect use of this equipment.WARRANTY: Guarantee is 12 months from purchase date, proof of whichwill be required for any claim.INFORMATION: For a copy of our latest catalogue and promotions call uson 01284 757525 and leave your full name and address, including postcode.For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products.Rechargeable SpotlightModel: AK436.V22006/95/EC Low Voltage Directive2004/108/EC EMC Directive2002/95/EC RoHS Directive2002/96/EC WEEE Directive9th January 2008Declaration of ConformitySigned by Mark SweetmanWe, the sole importer into the UK, declare that the product listed here is inconformity with the following standards and directives. The construction filefor this product is held by the Manufacturer and may be inspected, by anational authority, upon request to Jack Sealey Ltd.AK436.V2 - 1 - 0701081.2. BATTERY SAFETYDANGER! BE AWARE, LEAD-ACID BATTERIES MAY BE DANGEROUSIF NOT HANDLED WITH CARE AND ACCORDING TO THESEINSTRUCTIONS., Before exposing the battery for replacement, remove personal metallicitems such as rings, bracelets, necklaces and watches. A lead-acidbattery can produce a short-circuit current high enough to weld a ringto metal, which would cause severe burns. DO NOT smoke or allow a spark or flame in the vicinity of battery. Ensure the charger is switched off and disconnected from thespotlight before attempting to open the lamp unit. If the battery or wire terminals are corroded or dirty, clean them beforereplacing battery. DO NOT disassemble the battery for any reason. WARNING! DO NOT allow metal tools to touch both battery terminalssimultaneously. Arcing or short circuit will result. DO NOT allow battery wires to touch each other or to make contactwith any other metallic part. DO NOT cross-connect wires to the battery as this will damage the unit.Ensure positive (+) (RED) is to positive and negative (-) (BLACK) is tonegative. DO NOT leave battery in a discharged state, recharge battery immediately.If the lantern is not in use, recharge the battery every three months.Dispose of the old battery in accordance with local authority batteryregulations. DO NOT dispose of with regular refuse.3.1. CHANGING THE SPOTLIGHT BULB WARNING! Ensure the spotlight is turned off and the lens has cooledprior to changing the bulb.1. Undo the spotlight hood (fig.1.H) by turning it anti-clockwise.2. Carefully lift the reflector assembly revealing the spring clip (fig.5.1)and the cable connector (fig.5.2).3. Disconnect cable (fig.5.3).4. Squeeze the two ends of the spring clip together and remove thespring clip (fig.5.1).5. If unable to remove bulb, first remove screw and nut (fig.5.5)6. Pull bulb (fig.5.4) outward from the reflector.7. Hold the new bulb with a lint free cloth, (do not handle the bulb),and install by reversing the above procedure. WARNING! Beware of causing a short circuit.3. MAINTENANCEfig.501284 75750001284 703534 sales@sealey.co.ukSole UK DistributorSealey Group,Bury St. Edmunds, Suffolk.www.sealey.co.ukW e bemail3.2. CHANGING THE BATTERY WARNING! Ensure you read, understand and apply safetyinstructions relating to the battery before changing.1. Undo the spotlight hood (fig.1.H) by turning it anti-clockwise.2. Carefully lift the hood and reflector assembly.3. Remove the screws holding the printed circuit board (fig.6.3)4. Disconnect the red and black battery terminal wires removingthe black negative wire first (fig.6.2a,2b).5. Undo the four battery cover retaining screws (fig.6.1).6. Carefully raise the battery cover. WARNING! Beware of causing a short circuit.7. Carefully remove the battery.8. Replace with genuine Sealey battery and install by reversing theabove procedure.Note: Take care not to pinch or incorrectly connect any wires.9. Dispose of old battery in accordance with local authority batteryregulations. DO NOT dispose of with regular refuse.fig.612354PARTS LIST FOR AK436.V2 RECHARGEABLE SPOTLIGHTPart No DescriptionAK436.V2-B BulbAK436.V2-BAT Battery 6V 5AhAK436.V2-C Mains ChargerAK436.V2-CC Car Charger

/ 2

Related manuals for Sealey AK436.V2