Sealey AK437.V2 Instructions Manual

Also see for AK437.V2: Instructions

INSTRUCTIONS FOR:RECHARGEABLE SPOTLIGHT5,000,000 CANDLE POWERModel: AK437.V2Thank you for purchasing a Sealey Product. Manufactured to a high standard this productwill, if used according to these instructions and properly maintained, give you years oftrouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTETHE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSEFOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGEAND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY INSTRUCTIONS1.1. GENERAL! Ensure the spotlight is correctly charged before initial use.! When fully charged, spotlight must not be used for more than 20 minutescontinuously. To do so may damage the lamp." WARNING! The lens becomes very hot during operation.# DO NOT cover or block the lens during use.# DO NOT turn the spotlight on when it is being re-charged.# DO NOT shine directly into your, other personís or animalís eyes.# DO NOT stand the spotlight near any surface or item that may be adverselyeffected by the heat emitted by the lens.# DO NOT allow children to use the spotlight.# DO NOT handle or move the spotlight whilst it is being charged.# DO NOT use the spotlight if you suspect that the battery or the spotlightcasing is damaged.# DO NOT handle lamp bulb with your fingers. Use a soft lint-free cloth.! Ensure that correctly rated battery and bulb are used for replacements.! When not in use store the spotlight in a safe, dry, childproof location.AK437.V2 - 1 - 3007071.2. BATTERY SAFETYDANGER! BE AWARE, LEAD-ACID BATTERIES MAY BE DANGEROUS IFNOT HANDLED WITH CARE AND ACCORDING TO THESE INSTRUCTIONS.,! Before exposing the batteries for replacement, remove personal metallicitems such as rings, bracelets, necklaces and watches. A lead-acidbattery can produce a short-circuit current high enough to weld a ringto metal, which would cause severe burns.# DO NOT smoke or allow a spark or flame in the vicinity of batteries.! Ensure the charger is switched off and disconnected from thespotlight before attempting to open the lamp unit.! If the batteriesí terminals are corroded or dirty, clean them beforereplacing batteries.# DO NOT dis-assemble the batteries for any reason." WARNING! DO NOT allow metal tools to touch both battery terminalssimultaneously. Arcing or short circuit will result.# DO NOT allow battery wires to touch each other or to make contactwith any other metallic part.# DO NOT leave batteries in a discharged state, recharge batteriesimmediately. If the spotlight is not in use, recharge the batteries everythree months.# Dispose of the old batteries in accordance with local authority batteryregulations. DO NOT dispose of with regular refuse.4.1. CHANGING THE SPOTLIGHT BULB" WARNING! Ensure the spotlight is turned off and the lens has cooledprior to changing the bulb.1. Undo the spotlight hood (fig.1.A) by turning it anti-clockwise.2. Carefully lift the reflector assembly revealing the spring clip (fig.5.1)and the cable connector (fig.5.2).3. Disconnect cable (fig.5.3).4. Remove the spring clip (fig.5.1).5. Pull bulb (fig.5.4) outward from the reflector.6. Hold the new bulb with a lint free cloth, (do not handle the bulb),install by reversing the above procedure." WARNING! Beware of causing a short circuit.4. MAINTENANCE4.2. CHANGING THE BATTERIES"" WARNING! Ensure you read, understand and apply safetyinstructions relating to the battery before changing.1. Undo the spotlight hood (fig.1.A) by turning it anti-clockwise.2. Carefully lift the hood and reflector assembly revealing the fourbattery cover retaining screws (fig.6.1)3. Disconnect wire (fig.6.3a) from bulb cable (fig.6.3b) ." WARNING! Beware of causing a short circuit.4 Undo the four retaining screws.5. Carefully raise the battery cover (fig.6.2).6. Carefully remove battery terminal wires, noting cable connections,then remove both batteries.7. Replace with genuine Sealey batteries and install by reversing theabove procedure.Notes: a) Take care not to pinch or misconnect any wires.b) When replacing battery cover make sure that charging jack PCBis slotted into supports before replacing screws.8. Dispose of old batteries in accordance with local authority lead-acid battery regulations. DO NOT dispose of with regular refuse.1NOTE: It is our policy to continually improve products and as such we reservethe right to alter data, specifications and component parts without prior notice.IMPORTANT: No liability is accepted for incorrect use of this equipment.WARRANTY: Guarantee is 12 months from purchase date, proof of whichwill be required for any claim.INFORMATION: For a copy of our latest catalogue and promotions call uson 01284 757525 and leave your full name and address, including postcode.For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products.Rechargeable SpotlightModel AK437.V273/23/EEC Low Voltage Directive89/336/EEC EMC Directive2002/95/EC RoHS Directive2002/96/EC WEEE Directive30th July 2007Declaration of ConformitySigned by Mark SweetmanWe, the sole importer into the UK, declare that the products listed here are inconformity with the following standards and directives. The construction filesfor these products are held by the Manufacturer and may be inspected, by anational authority, upon request to Jack Sealey Ltd.01284 75750001284 703534 sales@sealey.co.ukSole UK DistributorSealey Group,Bury St. Edmunds, Suffolk.www.sealey.co.ukWebemailfig.6fig.5

/ 2

Related manuals for Sealey AK437.V2