Sealey AK2932 Manual

1. SAFETY WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using thisequipment, make sure you know where the nearest fire extinguisher is. WARNING! Always wear approved eye / face protection when operating the torch. WARNING! Do not use the torch if you notice damage to the workpiece or if there could be a gas leak from it. WARNING! Butane gas is extremely flammable, handle with care. WARNING! Always point the torch away from the eyes and body when igniting and during operation. WARNING! Do not put the torch down when it is lit, do not leave it unattended. WARNING! The flame is not easily visible in the bright daylight. WARNING! Ensure the flame is completely extinguished after use. Do not use water to cool the torch down. WARNING! Only use in a well ventilated area.8 DO NOT use the torch in an area where paint fumes, solvents or other flammable solids, liquids or gases pose a potentialhazard. Keep flammable material away from the torch when operating.8 DO NOT operate the torch when you are tired or under the influence of alcohol, drugs or intoxicating medication.8 DO NOT hold any workpiece by hand.8 DO NOT touch the workpiece close to the heated area as it will be very hot. Allow to cool.8 DO NOT operate the torch if it is damaged as this may cause failure and/or possible personal injury.8 DO NOT touch the top of the torch during or immediately after use, as it will be very hot. Allow to cool.8 DO NOT allow children to operate the torch.9 After use, apply the safety lock and allow the torch to cool before storing it.9 When not in use, store away from direct sunlight in a safe, dry, childproof location.8 DO NOT store at over 40°C, such as in a car in hot weather.2. INTRODUCTIONHeavy-duty butane powered heating and soldering torch. Fitted with piezoelectric ignition with anti-flare burner, ignition lock and continuousflame switch. Produces an adjustable flame with a maximum temperature of 1300°C and will operate on a single fill for up to 75 minutes.HEAVY-DUTY BUTANE SOLDERING TORCHMODEL NO: AK2932Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.Refer toinstructionmanualWear eyeprotection Wear protectiveclothingAK2932 Issue 2 14/04/23Original Language Version© Jack Sealey Limited

/ 2

Related manuals for Sealey AK2932