Sanyo VCC-ZM400P Instruction Manual

Also see for VCC-ZM400P: Service manual

Contents

VIEW SETTINGMOTION MASKING settingMasking target objects that are not desired for detection (swaying trees, flickers of light , etc.) will prevent unwanted alarm s from beinggenerated. This is done in the MOTION SETTING screen.1 Use the cursor button (j or l) to move the cursor toMASKING, and then use the cursor button (d or c) toselect ON. Then press the SET button.The MOTION MASKING screen will appear, and the maskpattern will be blinking in the upper left corner of the screen.2 Use the cursor button (j l d c) to move the maskpattern to the target object that is not to be detected,then press the SET button.Repeat these steps to set mask patterns in other locations.Note: To clear a mask pattern, press the SET button again onthe pattern.3 Finishing motion pattern settingUse the cursor button (j or l) to move a mask pattern tothe bottom area of the screen and continue holding it for 3seconds. The PRESET and MENU items will appear on thescreen. To close the menu screen or return to the previousscreen, select BACK or END for MENU and press the SETbutton.1 2MOTION SETTINGSIZE SET ‚MASKING ON ‚SENSITIVITY SET ‚ZOOM OFFINTERVAL 5SALARM SIGN OFFPRESET OFFMENU BACKMOTION MASKINGCONTINUE (ñ)MOTION MASKINGCONTINUE (ñ)English50