Sanyo VCC-ZM400P Instruction Manual

Also see for VCC-ZM400P: Service manual

Contents

LENS SETTING (LENS)3 AGC MAX GAIN settingUse the cursor button (j or l) to move the cursor toAGC MAX GAIN, and then use the cursor button (d orc) to select the gain.Available settings: Select the maximum AGC gain from+9dB, +12dB or +15dB.4 DNR settingUse the cursor button (j or l) to move the cursor toDNR, and then use the cursor button (d or c) to selectthe digital noise reduction setting (e.g. ON).Available settings:• ON: DNR (digital noise reduction) is applied. This reducesinterference at low luminance levels.• OFF: DNR is not applied.Note: Digital noise reduction operates when the gain controlincreases. In addition, blurring and ghosting of imagescan occur when moving images are being monitored,and so the resolution is also reduced slightly.5 BURST settingUse the cursor button (j or l) to move the cursor toBURST, and then use the cursor button (d or c) toselect the burst setting (e.g. ON).Available settings:• ON: The color burst signal is turned on.• OFF: This should normally be set to “OFF”.6 FOCUS settingUse the cursor button (j or l) to move the cursor toFOCUS, and then use the cursor button (d or c) toselect the focus setting (e.g. 1).Available settings:• 1: Near-infrared wavelength correction is set.(around 900 nm)• 2: Visible light spectrum is set.Note: This is set to “1” at the time of shipment from thefactory. If the images are out of focus, change it to “ 2”.D/N SETTING - AUTOAGC MAX GAIN +9·DNR OFFBURST OFFFOCUS 1LEVEL MIDPRESET OFFMENU BACK3 4 5 6D/N SETTING - AUTOAGC MAX GAIN +9·DNR ONBURST OFFFOCUS 1LEVEL MIDPRESET OFFMENU BACKD/N SETTING - AUTOAGC MAX GAIN +9·DNR ONBURST ONFOCUS 1LEVEL MIDPRESET OFFMENU BACKD/N SETTING - AUTOAGC MAX GAIN +9·DNR ONBURST ONFOCUS 1LEVEL MIDPRESET OFFMENU BACKEnglish25