Sanyo FW50C85T Owner's Manual

Sanyo FW50C85T Owner's Manual Manual pdf 39 page image

Network settings1 Press Z and use J K to Select Setup then press OK.2 Use H I J K to Select Network settings, then press OK.3 Adjust the following items.Manual network settings1 Use H I to Select Manual network settings, then press OK.Proxy configurationIP configurationWireless network settingNetwork selectionAppsReset network settingsHome networkSetting statusConnection testManual network settingsSamba interactive TV settingsNetwork selection2 Use H I to Select Network selection, then press OK.3 Use H I to Select the desired setting, then press OK.Wired If you connect to an Ethernet Cable, select Wiredto connect to the Internet.Wireless If you have a router with WPS function, selectWireless to connect to the Internet.Wireless network settingThis menu is displayed only when you set Wireless in Networkselection. In order to use a wireless network, you must set up aconnection to the AP (e.g. Wireless Router).2 Use H I to Select Wireless network setting, then press OK.AutoSearch for wireless networks automatically and select the SSID from thelist.3 Use H I to Select Auto, then press OK.4 The list of wireless networks will be displayed. Use H I to Selectthe appropriate the SSID, then press OK.Manually enter your SSIDAutoRouter 4Router 3Router 2Router 1ManualWPS codeSimple Connect● If you select the SSID with , WEP*2 / WPA / WPA2 Key entryscreen will appear. Enter the WEP*2 / WPA / WPA2 key of theselected wireless network using H I J K, then press OK.● If you select the SSID has a WPS, the WPS setting screen willappear. Use H I J K to Select a setting, then press OK.Simple ConnectSelect this Setting if your Router has a Wi-FiProtected Setup (WPS) button. Start Scanning forwireless networks on the TV after pressing theWPS button on your Router. If Connection Testfails, try Simple Connect again.*1 If it fails thenrefer to the Router’s Manual for more details.WPS codeSelect this Setting if your Router has a WPS butdoes not have a WPS button. Enter the 8-digitWPS PIN code shown on your TV in the Routersettings menu via PC before Connect is selected.ManualIf your wireless network with authenticationsetting (WEP*2, WPA or WPA2), WEP*2 / WPA /WPA2 Key entry screen will appear. Enter theWEP*2 / WPA / WPA2 key of the selectedwireless network using H I J K, then press OK.*1 WPS (Simple Connect) cannot be used when the security protocolis set to WEP. Change the Access Point’s security mode fromWEP to WPA or WPA2 (recommended).*2 WEP is not recommended to be used due to its Major securityflaws. Change the Security protocol on the Wireless Router toWPA or WPA2 (recommended) mode.Confirmation message will appear. Select OK to complete the settings.Note(s)● For a wireless network with authentication setting, key icon appears to the right hand of theSSID.● Signal icon shows the strength of the signal.● WEP*2 / WPA key appears as asterisks on the confirmation screen.● The wireless LAN supports following specifications.– Wireless standards: IEEE 802.11 a/b/g/n/ac– Frequency spectrum: 2.5GHz / 5GHz– Security protocol: WEP*2 / WPA / WPA239 .EnglishContinued on next page.