Sanyo FW50C85T Owner's Manual

Sanyo FW50C85T Owner's Manual Manual pdf 20 page image

Watching Channels from an ExternalDeviceSwitching Each Input Mode can easily switch with the Remote Controlbetween TV and external devices when they are connected to the unit.1 Turn On the Set-top Box or the Connected Device.① Press SOURCE and use J K to Select the Set-top Box or theConnected Device and wait a few seconds till the Picture appears.HDMI3HDMI2HDMI1Watch TV Video② Use the Remote Control of the Set-top Box or the Connected Deviceto Select Channels.Access the Home menu1 Press Z.Guide to Home menuSetupSource Home Network Apps MiracastWatch TVa Watch TV : Switches back to the TV Source if anotherSource is selected.b Source : To Select Connected devices.c Home Network : Accesses Home Network Menus.d Apps : Accesses Apps Menus.e Miracast : Accesses Miracast Menus.f Setup : Accesses Menus that allow you to changePicture, Sound and other TV Settings.Lock or unlock your device from the Home menuThis section describes how to lock or unlock specified device.1 Press SOURCE on the Remote Control.2 Use J K to Select a device to lock or unlock.3 Press OPTIONS on the Remote Control.4 Use H I to Select Lock or Unlock, then press OK.● If device lock is unlocked, Lock will be displayed. If device lock islocked, Unlock will be displayed at the top right of the deviceicons.5 Enter your PIN. Change PIN L p. 37● Once you have set PIN, PIN input menu does not appear after theunit is Turned on.Changing device typeYou can change device icons displayed in the source list.1 Press SOURCE on the Remote Control.2 Use J K to Select the desired device.3 Press red button on the Remote Control.4 Use H I to Select the desired type, then press OK.To reset the type● Press OPTIONS on the Remote Control at step 3, then select Originalicon.Scan connectionsYou can rescan TV connections and update the source list.Before you begin:You must set On in fun-Link control. L p. 341 Press SOURCE on the Remote Control.2 Use J K to move the cursor to any device.3 Press OPTIONS on the Remote Control.4 Use H I to Select Scan connections, then press OK.20 .EnglishContinued on next page.