Samsung WA52DG55 A Series User Manual

InstallationEnglish18Installation requirementsElectrical supply and grounding• AC 120 V / 60 Hz / 15 AMP fuse or circuit breaker is required.• Use an individual branch circuit. Connect only the washer to the circuit.To ensure proper grounding, the washer comes with a power cord featuring a three-prong grounding plugfor use in a properly installed and grounded outlet.Check with a qualified electrician or service person if you are not sure about the grounding.Do not modify the provided plug. If it does not fit the outlet, call a qualified electrician to install a properoutlet.WARNING• Do NOT use an extension cord.• Use only the power cord that comes with the washer.• Do NOT connect the ground wire to plastic plumbing, gas lines, or hot water pipes.• Improperly connected grounding conductors may cause electric shock.• To prevent unnecessary risk of fire, electrical shock, or personal injury, all wiring and grounding must bedone in accordance with local codes, or in the absence of local codes, in accordance with the NationalElectrical Code, ANSI/NFPA No. 70-Latest Revision (for the U.S.) or the Canadian Electrical Code CSAC22.1 – Latest Revisions and local codes and ordinances. It is your responsibility to provide adequateelectrical service for your washer.Water supplyProper water pressure for this washer is between 20-116 psi (137-800 kPa). Water pressure less than 20 psi(137 kPa) may cause the water valve not to close completely. or it may take longer to fill the drum, causingthe washer to turn off. Water taps must be within 4 ft. (122 cm) from the rear of the washer so that theprovided inlet hoses reach the washer.To reduce the risk of leaks:• Make sure water taps are easily accessible.• Turn off the taps when the washer is not in use.• Check for any leaks at the water inlet hose fittings on a regular basis.CAUTIONBefore using the washer for the first time, check all connections at the water valve and taps for any leaks.Untitled-3 18 2023-11-02 12:34:04