Menu
Samsung SSA-R2000V User Manual
                  |
12_ initializationinitializationBASIC OPERATIONSInitial State (when the power is supplied)When you apply power to the product, it will sound beep three times before entering Standby with the red indicatorturned on.Using the cardPresent the card to the product until you hear a beep and the green indicator turns on.The reader keeps the green indicator turned on while transferring the card data to thecontroller. When it is done, the green indicator turns off and for receiving the next card,the red indicator stays ON.Using the keypadHold down the keypad until you hear a beep. The reader transfers the keypad data to the controller.As soon as you press the keypad, the orange indicator turns on, followed by the reader transferring the keypad datato the controller. Then, only the red indicator turns on.LED ControlYou can control both green and orange indicators at will.To control the green indicator, connect the green-indicator control line (yellow) to NO of the controller relay output,and connect COM to GND. Set I/O of the controller; now you can control turning on/off the indicator.You can turn on/off the indicators according to the I/O settings of the controller, which can be applied to varioussituations. For more information about the I/O settings of the controller, refer to the user manual of the controller.To control the orange indicator, connect the gray line to NO of the controller.Buzzer ControlConnect the buzzer control input line (blue) to the NO port of the controller relay output, and GND to the COM port.You can configure the I/O settings of the controller so that it beeps. If the product continues to beep, it means thatthe buzzer control is working properly.The controller can use the I/O settings to set the buzzer control so that it sounds an additional beep for authorizedor unauthorized access upon user authentication.Furthermore, you can make various modifications according to the different I/O settings of the controller.For more information about the I/O settings of the controller, refer to the user manual of the controller.Card reading is not available while the buzzer control is sounding the buzzer.Tamper ControlYou can set the signal that you want to output if the device is dismantled forcibly.Connect the COM port (Pink line) of the product’s tamper switch to GND; connect the NC port (Light yellow) of thetamper switch to the input port of the controller. If the tamper of the reader operates, the controller produces an inputsignal and generates the corresponding output depending on the controller setting.SSA-R2000VX Y Z[ \ ]^ _ `lzjlzjWizzhTzYWWW |
Related manuals for Samsung SSA-R2000V
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved