Samsung OfficeServ500 Installation Manual

Also see for OfficeServ500: Programming manual General description

Contents

4-6 Chapter 4Installing Processor and Interface CardsMFM DaughterboardThis board (Figure 4-10) has no selectable options and installs in any available position of theMCP2 card when the system has one cabinet installed (Figure 4-1). If the system has more thanone cabinet, the MFM board must be installed in position LOC3 of the MCP2 card, any availableposition of the SCP2 card (Figure 4–3) or any available position of the LCP2 card(s) (Figure 4–4).Up to three MFM boards can be installed in a system (one on the MCP2 or SCP2 and one oneach LCP2). The MFM board is used to provide an additional 12 DSP circuits for DTMF and tonedetection.To install the MFM board, remove the two screws holding the MCP2 or LCP2 protective casingtogether (Figure 4-6) or remove the four screws holding the SCP2 case together (Figure 4-8)and separate the two halves of the case. Place the MFM board face down over the twoconnectors, taking care to properly line them up, and press gently on the back of the board toseat it. The card casing can now be reassembled if all required daughterboards have beeninstalled.NOTE: Only one MFM board can be installed on each processor card.RCM DaughterboardThis board (Figure 4-11) has no selectable options and installs in any available position of theMCP2 card when the system has one cabinet installed (Figure 4-1). If the system has more thanone cabinet, the RCM board must be installed in position LOC3 of the MCP2 card (Figure 4-1),any available position of the SCP2 card (Figure 4-3) or any available position of the LCP2card(s) (Figure 4-4). Up to three RCM boards can be installed in a system (one on the MCP2 orSCP2 and one on each LCP2). The RCM board is used to provide 14 Caller ID DSP circuits forCaller ID detection on loop start trunks (TRK B and 8TRK).To install the RCM board, remove the two screws holding the MCP2 or LCP2 protective casingtogether (Figure 4-6) or remove the four screws holding the SCP2 case together (Figure 4-8)and separate the two halves of the case. Place the RCM board face down over the twoconnectors, taking care to properly line them up, and press gently on the back of the board toseat it. The card casing can now be reassembled if all required daughterboards have beeninstalled.MODEM DaughterboardThis board (Figure 4-12) has no selectable options and installs on the IOM board (Figure 4-13).The Modem board provides a 56Kbps/V90 modem for communicating with the system remotely.Place the Modem board face down over the two connectors, taking care to properly line them up,and press gently on the back of the board to seat it.