9ASSEMBLING YOUR KEYSET• Place the keyset face down on a flat surface.• Insert notched ends of the support bracket into the channels located in theupper section of the bottom panel. Push towards the top of the keyset to lockin.• Plug the handset cord into the jack marked with the symbol.• Route the handset cord out the RIGHT side of the keyset as you look at it facedown.• Plug the four-conductor line cord, from the wall, into the jack with thesymbol on the bottom of the keyset.LCD PanelSoft ButtonScroll ButtonStatus IndicatorKeysetSupportMicrophoneConference ButtonSpeaker ButtonHold ButtonTransfer ButtonDial ButtonRedial ButtonVolume ButtonProgrammableButtons (7)DS 5007S8DS 5064B AOM64 PROGRAMMABLE KEYS WITHRED LIGHTS Used to call stationsdirectly, to indicate busy conditions ofother stations, for One Touch dialingand many other system features.KEYSET DAUGHTER MODULE [5021D & 5014D ONLY]DS 5021D keysets can have one type of daughter module installed to enhance theoperation of the keyset, the FDBF. The standard speakerphone mode of operationfor the DS 5021D is “half duplex”. This means that you cannot transmit and receivespeech at the same time. Adding a FDBF to your keyset will convert the speaker-phone into full duplex mode enhancing it operation. In addition the FDBF mayhave up to three (3) external microphones attached to it for conference room typeapplications. These microphones require an “EXTMIC” key programmed on thekeyset to activate or deactivate them.
