Samsung OFFICESERV 100 Series System Administration & Special Features Manual

Also see for OFFICESERV 500 Series: Service manual System administration guide Quick setup guide Quick setup guide Quick setup guide

Contents

12Failure to enter the time using the 24 hour clock will cause the date to change at12:00 P.M. Open customer programming and follow the instructions below.ACTION DISPLAY1. Press TRSF and then dial 505 OLD:6010184:0047Display shows NEW:WMMDDYY:HHMM2. Enter the new time and date using OLD:6010184:0047the above format NEW:3020994:14453. Verify the time and date and reenter OLD:3020994:1445them if necessary NEW:WMMDDYY:HHMM4. Press TRSF to store and exitprogramming OR press SPK to storeand advance to the next programIf you have entered invalid data, you will receive an [ INVALID ENTRY ] message forthree seconds. Reenter the correct date and time. If the information you entered isincorrect, repeat the procedure.RESET STATION PASSCODESTO DEFAULTIndividual keyset users can set or change their own individual passcodes. Thesepasscodes are used to lock and unlock keysets, override toll restriction and accessthe DISA feature. At times, it may be necessary for the system administrator toreset a station’s passcode to default “1234.”This program cannot be used to displaypasscodes, only to reset them.PROGRAM KEYSUP & DOWN - Select the extension number.HOLD - Press to reset the passcode.Open customer programming and follow the instructions below.ACTION DISPLAY1. Press TRSF and then dial 101 [201] PASSCODEDisplay shows PASSCODE:132. Dial the station number OR use the [205] PASSCODEUP and DOWN keys to scroll through PASSCODE:the keyset numbers and press theright soft key to move the cursor right3. Press HOLD to reset the passcode [205] PASSCODEPASSCODE : 12344. Press the right soft key to return tostep 2 OR press TRSF to store and exitprogramming OR press SPK tostore and advance to the next programDEFAULT DATA: ALL STATION PASSCODES = 1234PROGRAM STATION NAMESThis program is used to assign a character name or identification for each exten-sion. You may assign a name of 11 characters long.PROGRAM KEYSUP & DOWN - Used to scroll and move cursor.KEYPAD - Used to enter characters.HOLD - Press to clear entry.Open customer programming and follow the instructions below.ACTION DISPLAY1. Press TRSF and then dial 104 [201] STN NAMEDisplay shows2. Dial station number (e.g., 205) [205] STN NAMEOR press UP or DOWN to select thestation and press the right soft key tomove the cursor3. Enter the station name using the [205] STN NAMEprocedure described on the next page SAM SMITHand press the right soft key to return tostep 2