Samsung HT-J7750W User Manual

Also see for HT-J7500W: User manual User manual User manual

25 - EnglishSettings6. The Network connection fail screen appears.Use:; buttons to select IP Settings, and thenpress the OK button.7. Select the IP setting field, and then set it toEnter manually.8. Select a network parameter to enter (IPAddress, for example), and then press OKbutton. Use the 78 buttons on the remotecontrol to enter the numbers for the parameter.Or use the Num keypad to enter a parameternumber. Press and hold the 123 button untilthe Num pad appears on the screen. When theNum pad appears, select a number using the78:; button and then press the OK button.Use the :; buttons on the remote controlto move from entry field to entry field within aparameter. When done with one value, press theOK button.9. Press the , or . button to move to anotherparameter, and then enter the numbers for thatparameter following the instructions in Step 8.10. Repeat Steps 8 and 9 until you have filled in allparameters.✎ You can get the Network parameter values fromyour Internet provider.11. When finished, select OK, and then press theOK button. The Security screen appears.12. On the Security screen, enter your network'ssecurity code or pass phrase. Enter letters byselecting a letter with the 78:; buttons, andthen pressing the OK button.13. When finished, select Done at the right of thescreen, and then press the OK button. Theproduct verifies the network connection andthen connects to the network.14. After the home cinema verifies the network,select OK, and then press the OK button.✎ You can also begin the Manual Network setup bygoing to Settings > Network > Network Status. WPS(PBC)One of the easiest ways to set up the wirelessnetwork connection is using the WPS(PBC) function.If your wireless router has a WPS(PBC) button, followthese steps:After following Steps 1 to 3 in "Configuring YourNetwork Connection" on page 23:1. In the Network Settings screen, changeNetwork type to Wireless. The productsearches for and then displays a list of theavailable networks.2. Scroll the list down, select WPS(PBC), and thenpress the OK button.3. Press the WPS(PBC) button on your routerwithin two minutes. Your product automaticallyacquires all the network settings values it needsand connects to your network after the networkconnection is verified.4. When it is done, highlight OK, and then pressthe OK button.✎ For a WPS connection, set your wireless router’ssecurity encryption to AES. WEP securityencryption does not support a WPS connection.Wi-Fi DirectThe Wi-Fi Direct function allows you to connectWi-Fi Direct devices to the product and each otherusing a peer-to-peer network, without a wirelessrouter.✎ Some Wi-Fi Direct devices may not support theDLNA function if connected via Wi-Fi Direct. Ifthis is the case, change the network connectionmethod you used to connect the device to thehome cinema.✎ Wi-Fi Direct transmissions can interfere withBluetooth signals. Before you use the Bluetoothfunction, we strongly recommend that you turn offthe Wi-Fi Direct function on any device in whichit is currently on.1. Turn on the Wi-Fi Direct device and activate itsWi-Fi Direct function.2. In the Home screen, select Settings, and thenpress the OK button.3. Select Network, and then press the OK button.4. Select Wi-Fi Direct, and then press the OKbutton.The Wi-Fi Direct devices that you can connectthe home cinema to appear.