Samsung HT-J7750W User Manual

Also see for HT-J7500W: User manual User manual User manual

22 - EnglishSettingsRadio Setup~ To listen to the radio, you must connect thesupplied FM antenna.Operating the Radio with the Remote Control1. Press the SOURCE button to select FM.2. Tune to the desired station.~ Preset Tuning 1 : Press the PRESET buttonto select PRESET, and then press the 78buttons to select a preset station.- Before you can tune to preset stations, youmust add preset stations to the product'smemory.~ Manual Tuning : Press the PRESET buttonto select MANUAL, and then press the 78buttons to tune to a lower or higher frequency.~ Automatic Tuning : Press the PRESET buttonto select MANUAL, and then press and holdthe 78 buttons to automatically search theband.Selecting Mono or StereoPress the ST/MO button.~ Each time you press the button, the soundswitches between STEREO and MONO.~ In a poor reception area, select MONO for a clear,interference-free broadcast.Presetting StationsExample : Presetting FM 89.10 into memory.1. Press the SOURCE button to select FM.2. Press the 78 buttons to select <89.10>.3. Press the MEMORY button.~ NUMBER flashes on the display.4. Press the MEMORY button again.~ Press the MEMORY button before NUMBERdisappears from the display on its own.~ After you press the MEMORY button,NUMBER disappears from the display and thestation is stored in memory.5. To preset another station, repeat steps 2 to 4.~ To tune to a preset station, press the PRESETbutton to select PRESET, and then press the78 buttons to select the preset station.Recording FM RadioYou can record your favorite radio broadcast on ainserted USB storage device.1. Insert a USB device into the USB jack on thefront of the product.2. Press the SOURCE button to select FM, andthen then press the 78 buttons to select thestation you want to record.3. Press the A (Red) button to start recording theradio broadcast. Recording begins.~ The recorded time is displayed on the left andthe recording time still available, based onthe amount of free space in the USB storagedevice, is displayed on the right.4. Press the e (EXIT) button to finish yourrecording. The recording is stopped and savedas an .mp3 file at the same time. To play therecorded file, refer to "Playing Files on a StorageDevice".✎ The recorded file is saved in the Tuner folder whichis created automatically.✎ Only the (OPEN/CLOSE), (POWER),e (EXIT), (MUTE), and VOL +/-, buttons areoperable while FM radio is being recorded.✎ If you don't press any buttons while recording, thescreen saver will be enabled.✎ Sound effects, such as DSP, EQ, etc., are notrecorded during FM radio recording.✎ The radio is recorded at a set, default volumeeven if you change the volume or press the(MUTE) button during the recording process.✎ If you remove the USB device or Power Cableduring the recording process, the portion of thefile which has already been recorded may not playback.✎ Recording will not start if the remaining free spacein the USB storage device is less than 2MB.✎ If the USB device is removed or has insufficientspace (under 2MB), the appropriate message isdisplayed and the recording stops.