English - 23Top nozzle1. Check whether the nozzle holes areclogged by food particles.2. If cleaning is needed, remove the nozzle.3. To remove the nozzle, pull out the upperrack fi rst, unfasten the nozzle cap by turningit counterclockwise, and then remove theupper nozzle.4. Clean the nozzle, re-insert it, and thenfasten the nozzle cap to the nozzle byturning the cap clockwise.5. Check whether the nozzle is engagedcorrectly by rotating it by hand.CLEANING THE FILTER1. Remove the lower rack first.2. Rotate the fi lter handle counterclockwise to unfasten the fi ltercompartment door.3. Remove the fi lter door, and then thefl at micro fi lter underneath.4. Remove any dirt or other remainsfrom the micro fi lter and the fi lter door,and then rinse them under runningwater.5. Re-install the flat micro fi lter, and then the fi lter door.6. Rotate the fi lter door handle clockwise to lock the fi lter door.Once a month, clean the filter for better washing performance.If the fi lter door does not close properly, cleaning performance will be decreased.STORING YOUR DISHWASHERIf you need to store your dishwasher for an extended period of time, first drain and disconnect it. If youleave water in the hoses and internal components, you can damage the dishwasher.After draining and disconnecting the dishwasher, be sure to turn off the water supply valve and circuitbreaker.CAUTION04 cleaning and maintaining12CapnozzleFilter with handle Flat micro filterDW80H994_DD68-00164B_EN.indd Sec5:23DW80H994_DD68-00164B_EN.indd Sec5:23 2015-01-06 4:17:022015-01-06 4:17:02