Samsung DVD-R100 Quick Setup Manual

Also see for DVD-R100: Quick setup guide Update guide Firmware update guide Instruction manual Instruction manual

Contents

Step Getting ConnectedStep Basic OperationQuick Setup GuideStepStep Getting ConnectedSelect one of the following three types of connections:Antenna + DVD Recorder + TVAntenna + Set-Top Box or VCR + DVD Recorder + TVAntenna + DVD Recorder + TVConnect the signal source to the DVD RecorderUse a TV antenna or coaxial cable to connect the signal sourcecoming from the antenna or wall to the VHF/UHF RF-IN jack on theDVD Recorder.Connect the DVD Recorder to the TVUse the supplied RF cable to connect RF-OUT on the DVDRecorder to the ANT jack on the TV. Then use the Video/AudioCable to connect ANALOG AUDIO OUT(R/L)/VIDEO OUT jacks onthe DVD Recorder to the Audio & Video jacks on the TV. For better picture quality, if your TV has an S-Video jack, you canuse S-Video cable instead of the yellow video connector on theVideo/Audio cable. For the best picture quality, if your TV has Component videojacks, you can use component cables instead of the yellow videoconnector on the Video/Audio cable.If you have an AV amplifierConnect either audio cables from the ANALOG AUDIO OUT jackson the DVD Recorder to the LINE IN jacks on your AV amplifier,or a digital cable from the DIGITAL AUDIO OUT (COAXIAL orOPTICAL) jack on the DVD Recorder to the DIGITAL AUDIO INjack on your AV amplifier.The VHF/UHF RF OUT jack of this product sends only signals received through the antenna. It does not output audio/video signals.You must use one of the following connections on this unit.This Recorder will only record onDVD-R, DVD-RW and DVD-RAM discs.C Samsung Electronics Printed in KoreaEnglish-1

/ 4

Related manuals for Samsung DVD-R100