Samsung DS 5021D KEYSET General Description Manual

Also see for OFFICESERV 7100: Quick guide System administration guide User guide User manual User guide

Contents

2.1PART 2. HARDWARE DESCRIPTIONS2.1 SYSTEM CABINETThe OfficeServ 7100 cabinet has three slots to mount boards, an AC to DC power supply, cooling fan, a batterybackup connector and power on/off switch. The cabinet is designed to be rack mounted in a 19 inch rack, wall-mounted with a wall-mounted bracket or placed on a table top. Slot 0 is exclusively used for the MP10 processorcard, and slots 1 and 2 are 64 channel universal slots that the UNI cards or other OfficeServ 7200/OfficeServ 7400station/trunk cards can be installed in.2.2 PROCESSOR CARDSMP10 (MAIN PROCESSOR CARD)This is the main processor controlling system operation. The MP10 always goes in slot 0 of the main cabinet. TheMP10 provides a LAN connection, a MISC port (external page, MOH/BGM, loud/common bell), an SIO port(Samsung Maintenance Only), four universal ports for either digital phones or power of Ethernet ports (dependanton the type of daughterboard module plugged in), a internal modem slot, and a multimedia card (MMC+) slot whichcan accommodate a 256MB card containing the system software. The MP10 also includes embedded AutomatedAttendant,Voicemail, and MGI channels (license key required). The MP10 card cannot migrate to the OfficeServ 7200or OfficeServ 7400 systems.The MP10 have a connector for mounting either a 4DLM card or a 4SWM card. When the 4DLM card is installedon the processor it will provide an interface for 4 Digital telephone sets. When the 4SWM card is installed on theprocessor it will provide an interface for 4 power over ethernet (POE) ports. The MP10 also has a connector formounting the optional modem board. This modem board can be used for remote access to system administra-tion at installation that do not have a LAN or WAN connection. This is the same modem card used in the otherOfficeServ systems. If the 4SWM is installed the switch and LAN is automatically connected by way of the back-plane. In addition it may be used as a backup for LAN connectivity.2.2.1 EMBEDDED APPLICATIONSVOICEMAIL/AUTO ATTENDANTThe MP10 processor has the voicemail and automated attendant application embedded onto the card.The VMAAis designed to meet the demands of the sophisticated voice mail user without sacrificing simplicity. TheAutomated Attendant is available with four ports for processing voicemail/AA traffic routed to the AutomatedAttendant.The same four ports can be enabled to perform both the voicemail and automated attendant functionof answering calls and storing messages into mailboxes for each extension.MEDIA GATEWAY INTERFACEEight (8) MGI channels are embedded on the MP10 processor, and can be enabled (licensed in 1 port increments)to support VoIP functions such as IP phones, IP networking, and IP trunking. The embedded MGI channels can beenabled to support the following capabilities:• IP Phones• IP Networking (Network multiple systems over an SPNet IP Network)*• G.729 CODEC, G.723.1, G.711, G.729A CODECs• IP Trunking (SIP/H.323)• T.38 Fax CODEC• Inband or Out-of-band signaling of DTMF tones*The OfficeServ 7100 can network using QSig over PRI or SP-Net over IP to other Samsung OfficeServ systems.