Samsung CY-SWR1100 User Manual

Also see for CY-SWR1100: Product highlights Quick installation guide User manual

Page 66SamSung WireleSS router uSer’S manualYou can configure the following parameters:Enable DHCP PD: Select this option to enable DHCP PD.LAN IPv6 Address: Enter the LAN IPv6 address used here. This address must be in the ‘/64’ subnet.LAN IPv6 Link-Local Ad-dress:Displays the LAN IPv6 Link-Local address used here.Use this section to configure the internal network settings of your router. The LAN IPv6 Link-Local Address is the IPv6 Ad-dress that you use to access the Web-based management interface. If you change the LAN IPv6 Address here, you may needto adjust your PC’s network settings to access the network again. You can use DHCP-PD to acquire a IPv6 prefix for the LANinterface.You can configure the following parameters:Auto-Configuration: You can check this option to enable the auto-configuration feature.Auto-Configuration Type: You can select the auto-configuration type used here. Choose Stateless or Stateful(DHCPv6).Router AdvertisementLifetime:This option is only available when the auto-configuration type is set to Stateless. Enterthe router advertisement lifetime value used here.IPv6 Address Range(Start):This option is only available when the auto-configuration type is set to Stateful. Enter thestart IPv6 Address of the DHCPv6 range for your local computers.IPv6 Address Range(End):This option is only available when the auto-configuration type is set to Stateful. Enter theend IPv6 Address of the DHCPv6 range for your local computers.IPv6 Address Lifetime: This option is only available when the auto-configuration type is set to Stateful. Enter theIPv6 Address Lifetime (in minutes).Click the Save Settings button to accept the changes.Click the Don’t Save Settings button to discard the changes.