75EnglishSecuring the TV to the WallCaution: Pulling, pushing, or climbing onto the TV may cause the TV to fall. In particular, ensure that your children do not hang over ordestabilize the TV; doing so may cause the TV to tip over, resulting in serious injuries or death. Follow all safety precautions provided on theincluded Safety Flyer. For added stability, install the anti-fall device for safety purposes, as follows.To avoid the TV from falling1. Put the screws into the clamps and firmly fasten them onto the wall. Confirm that the screws have been firmly installed onto the wall.✎ You may need additional material such as an anchor depending on the type of wall.✎ Since the necessary clamps, screws, and string are not supplied, please purchase these additionally.2. Remove the screws from the centre back of the TV, put the screws into the clamps, and then fasten the screws onto the TV again.✎ Screws may not be supplied with the product. In this case, please purchase the screws of the following specifications.3. Connect the clamps fixed onto the TV and the clamps fixed onto the wall with a strong string and then tie the string tightly.✎ NOTE• Install the TV near to the wall so that it does not fall backwards.• It is safe to connect the string so that the clamps fixed on the wall are equal to or lower than the clamps fixed on the TV.• Untie the string before moving the TV.4. Verify all connections are properly secured. Periodically check connections for any sign of fatigue for failure. If you have any doubt about the securityof your connections, contact a professional installer.Anti-theft Kensington LockThe Kensington Lock is not supplied by Samsung. It is a device used to physicallyfix the system when using it in a public place. The appearance and lockingmethod may differ from the illustration depending on the manufacturer. Refer tothe manual provided with the Kensington Lock for additional information on properuse.To lock the product, follow these steps:✎ Please find a “K” icon on the rear of the TV. A kensington slot is beside the“K” icon.1. Wrap the Kensington lock cable around a large, stationary object such as deskor chair.2. Slide the end of the cable with the lock attached through the looped end of the Kensington lock cable.3. Insert the locking device into the Kensington slot on the product (1).4. Lock the lock.✎ These are general instructions. For exact instructions, see the User manual supplied with the locking device.✎ The locking device has to be purchased separately.✎ The location of the Kensington Lock may be different depending on its model.1[Hotel-590_690_790]BN68-04282R-Eng.indd 75 2012-07-26 오후 2:46:59