Samsung 590 Series Installation Manual

Also see for 590 Series: Quick setup guide User manual

Contents

29EnglishRemote control code is set to 0. If you want tochange Remote control code, enter the digit youwant to change.¦ Multi Code RemoconMulti Code Remocon is a special transmitter which is designed to control each TVs with one remote.This function is useful where there is more than one TV in one location like hospital Set ID number will be displayed in sourceosd. It is possible to support up to 9 different remote key transmission for multi code.Initial ID code which each TV has is “0”.– ID code could be set and reset in Analog TV mode or PC mode. (not available in TTX channel or DTV channel)– ID code could be from 0 to 9.– Press Blue Key for over 7 seconds and the digit key a user wants to set.– Set ID OSD will be displayed in central position.– The following words will be displayed. “Remote control code is set to x. If you want to change Remote control code.Enter the digit you want to change.” (x is the digit number) This OSD will be kept displaying until exit key is input.– For example, TV and Remote will be set ID code #1 if user presses #1.– The following words will be displayed.“Remote control code is changed to 1” Then TV can be controlled by only remotewhich has same ID code with TV’s.– If ID code does not match between remote and TV, the following words will be displayed. “ TV ID x”(x is the TV’s ID)– To reset ID code, press Yellow key for over 3 seconds. ID code of both TV and Remote will be reset to “0”. “Remotecontrol code is set to 0.” will be displayed.[Hotel-590_690_790]BN68-04282R-Eng.indd 29 2012-07-26 오후 2:46:51