User’s Manual 193. RUNNING SAMPLE PROGRAMSTo develop and debug programs for the RCM3365/RCM3375(and for all other Rabbit hardware), you must install and useDynamic C.3.1 IntroductionTo help familiarize you with the RCM3365 and RCM3375 modules, Dynamic C includesseveral sample programs. Loading, executing and studying these programs will give you asolid hands-on overview of the RCM3365/RCM3375’s capabilities, as well as a quickstart using Dynamic C as an application development tool.NOTE: The sample programs assume that you have at least an elementary grasp of the Cprogramming language. If you do not, see the introductory pages of the Dynamic CUser’s Manual for a suggested reading list.More complete information on Dynamic C is provided in the Dynamic C User’s Manual.In order to run the sample programs discussed in this chapter and elsewhere in this manual,1. Your RCM3365/RCM3375 module must be plugged in to the Prototyping Board asdescribed in Chapter 2, “Getting Started.”2. Dynamic C must be installed and running on your PC.3. The RCM3365/RCM3375 module must be connected to your PC either through theserial programming cable or through an Ethernet cable/network if you have aRabbitSys-enabled RCM3365.4. Power must be applied to the RCM3365/RCM3375 through the Prototyping Board.Refer to Chapter 2, “Getting Started,” if you need further information on these steps.Since the RCM3365 and the RCM3375 run at 44.2 MHz and are equipped with a fast pro-gram execution SRAM, remember to allow the compiler to run the application in the fastprogram execution SRAM by selecting Code and BIOS in Flash, Run in RAM from theDynamic C Options > Project Options > Compiler menu.To run a sample program, open it with the File menu, then press function key F9 to com-pile and run the program.
