B – Command Line InterfaceSet Setup CommandB-86 59096-02 CSsnmpPrompts you in a line-by-line fashion to change SNMP configuration settings.Table B-25 describes the SNMP fields. For each parameter, enter a new value orpress the Enter key to accept the current value shown in brackets.Table B-25. SNMP Configuration SettingsEntry DescriptionSNMPEnabled Enables (True) or disables (False) SNMP on the switch. Thedefault is True.Contact Specifies the name of the person to be contacted to respond totrap events. The name can be up to 64 characters excluding #,semicolon (;), and comma (,). The default is undefined.Location Specifies the name of the switch location. The name can be upto 64 characters excluding #, semicolon (;), and comma (,).The default is undefined.Trap [1-5] Address Specifies the workstation IP address to which SNMP traps aresent. The default address for trap 1 is 10.0.0.254. The defaultaddress for traps 2–5 is 0.0.0.0. Addresses, other than 0.0.0.0,for all traps must be unique.Trap [1-5] Port Specifies the workstation port to which SNMP traps are sent.Valid workstation port numbers are 1–65535. The default is162.Trap [1-5] Severity Specifies the severity level to use when monitoring trap events.The default is Warning.Trap [1-5] Version Specifies the SNMP version (1 or 2) to use in formatting traps.The default is 2.Trap [1-5] Enabled Specifies whether traps (event information) are enabled or dis-abled (default).ReadCommunity Read community password that authorizes an SNMP agent toread information from the switch. This is a write-only field. Thevalue on the switch and the SNMP management server mustbe the same. The read community password can be up to 32characters excluding #, semicolon (;), and comma (,). Thedefault is “public”.WriteCommunity Write community password that authorizes an SNMP agent towrite information to the switch. This is a write-only field. Thevalue on the switch and the SNMP management server mustbe the same. The write community password can be up to 32characters excluding #, semicolon (;), and comma (,). Thedefault is “private”.
