B – Command Line InterfaceImage CommandB-38 59096-02 CSImage CommandManages and installs switch firmware.Authority Admin sessionSyntax imagecleanupfetch [account_name] [ip_address] [file_source] [file_destination]installlistunpack [file]Keywords cleanupRemoves all firmware image files from the switch. All firmware image files areremoved automatically each time the switch is reset.fetch [account_name] [ip_address] [file_source] [file_destination]Retrieves image file given by [file_source] and stores it on the switch with the filename given by [file_destination]. The image file is retrieved from the FTP serverwith the IP address given by [ip_address] and an account name given by[account_name]. If an account name needs a password to access the FTP server,the system will prompt you for it.installDownloads firmware from a remote host to the switch, installs the firmware, thenresets the switch (without a power-on self test) to activate the firmware. This resetis disruptive. The command prompts you for the following: IP address of the remote host An account name and password on the remote host Pathname for the firmware image filelistDisplays the list of image files that reside on the switch.unpack [file]Installs the firmware file given by [file]. After unpacking the file, a messageappears confirming successful unpacking. The switch must be reset for the newfirmware to take effect. Enter the Hotreset command to attempt a non-disruptiveactivation.
