627. To prevent the display from falling, tighten the screws at two points evenly. (The appropriate choice of fixing screwsdepends on the material, structure, and strength of the table. Use high-quality screws.)¶ First read the instruction manual. Observe the following points when attaching the stand frame to theplasma display.1.Use 45-mm bolts (shorter bolts).2.Before securing the display with the bolts, verify that the positions of the display nuts match the bolt holepositions in the stand frame.3.When mounted to the stand frame, the display must have zero clearance and/or backlash to the stand frame,or the plasma display nut will be damaged (Fig.1). Loosen the four bolts securing the joint pipe, as indicated bythe arrow, and adjust to remove any clearance or backlash. Then mount the display (Fig.2).7 Angle adjustments(Variable up to 20° from vertical)Do not loosen thisscrew.Loosen these screws on the leftand right sides and decide on theangle you want. Then, tightenthe screws.7 Backlash adjustmentIf the stand frames placed on the table have backlash,adjust the fixture.1. Loosen the 4 screws used to attach the joint pipes.2. Adjust the stand frames to eliminate backlash beweenthe table and the stand frames, and then tighten theloose screws.Fig. 1 Fig. 2 Precautions for assemblyClearance, backlashMounting standard metal fixtures (PDK-4001)
