17EnInstallation and Connections English1 2How to route cablesSpeed clamps and bead bands are included with theplasma display for bunching cables together. Oncecomponents are connected, follow the following steps toroute cables.The illustration depicts the PDP-505CMX/PDP-504CMX/PDP-50MXE10/PDP-50MXE11/PDP-50MXE1/PDP-50MXE1-S with video card PDA-5003. * As viewed from the rear of the display.Installation and Connections1 Organize cables together using the providedspeed clamps.Insert 1 into an appropriate hole on the rear of theunit, then snap 2 into the back of 1 to fix the clamp.Speed clamps are designed to be difficult to undoonce in place. Please attach carefully.To attach the speed clamps to the displayConnect the speed clamps using the 6 holes markedwith “‡” below, depending on the situation.To remove speed clampsUsing pliers, twist the clamp 90° and pull it outward.In some cases the clamp may have deteriorated over timeand may be damaged when removed.2 Bunch separated cables together and secure themwith the provided bead bands.Do not allow excessive stress to be placed on theends of cables.NoteCables can be routed to the right or left.The illustration depicts the PDP-505CMX/PDP-504CMX/PDP-50MXE10/PDP-50MXE11/PDP-50MXE1/PDP-50MXE1-S with video card PDA-5003.* As viewed from the rearof the display.
