49En06 EnglishNetwork SettingsThe network settings are made here. If settings are changed, be sure to either close the Setup screen or return to thetop Setup screen, then turn off the power. The settings are reflected when the power is turned back on (aside from theWake Up On LAN setting). For details on this unit’s network function, see page 70.1. For instructions on inputting numbers, see page 38.2. For instructions on inputting characters, see page 39.3. The unit’s clock is set automatically at the following times:– When the unit’s power is turned on– At intervals of 1 hour after the unit’s power is turned on– When the NTP-related settings are changedCaution• Prior permission from the distributor is required in order to access NTP servers on the Internet.Play MenuFor details, see page 39.Setting item Settings DescriptionNetwork Connection Disable Select this when not using the LAN function.Enable Select this when using the LAN function.TypeAuto IP The IP address is set automatically.DHCP The network settings are acquired from the DHCP server.Manual Set the IP address manually.IP Address Input this unit’s IP address.1Subnet Mask Input the subnet mask.1Default Gateway Input the default gateway.1Primary DNS Input the primary DNS server’s IP address.1Secondary DNS Input the secondary DNS server’s IP address.1Wake Up On LANOff The Wake Up On LAN function is disabled (page 70).On The Wake Up On LAN function is enabled (even if Network Connection is set toDisable).MAC Address Displays the MAC address.FTP Username Input the FTP username. 2 (Default value: HDVIDEO)FTP Password Register the FTP password.1 (Default value: PASS)FTP Port Input the FTP port.1 (Default value: 00021)Remote Port Sets the remote port.1 (Default value: 10001)Proxy Address To use the proxy server when connecting to the Internet to use the RSS function, set the address. 2Proxy Port Set the proxy server’s port number. 1 (Default value: 01234)NTPDisable This unit’s clock is set to the time set at Clock Setting (page 47).Enable This unit’s clock is set automatically by acquiring the time information from theNTP server.3 Clock Setting cannot be set (page 47).NTP Server Address Set the NTP server’s IP address or URL.2Time Zone GMT ± **:**(GMT ± 00:00)Set the offset time with respect to the time acquired from the NTP server (GMT).
