Pioneer Elite PRO-950HD Operating Instructions Manual

Also see for Elite PRO-1150HD: Specifications

Contents

27EnBasic Operations 06Watching TV channelsUnless you set up TV channels that you can watch under thecurrent conditions, you cannot tune in those channels. For theprocedure, see Setting up TV channels on page 36.Note• When watching a digital TV program, you may see emergencyalert messages scrolling at the top of the screen. Thosemessages are broadcasted by TV stations as necessary whenin emergency situations.Selecting the antennaAfter confirming that the Mode switch on the remote control unithas been set to “TV”, press ANT on the remote control unit toselect antenna A or B.• Make this selection depending on the connections to theantenna input terminals at the rear of the plasma display (page23).• While watching a broadcast, press ANT to view the imagereceived from the other antenna.• Pressing ANT while watching in the multiscreen mode (TVimage and video image) with TV selected will display the TVimage of the other antenna.• Pressing ANT while watching in the multiscreen mode withtwo TV images displayed will not have any effect.Changing channelsTo increase the channel number, press CH + on the remotecontrol unit. To decrease the channel number, press CH –.• CHANNEL +/– on the plasma display operates the same as CH+/– on the remote control unit.• Press CH RETURN to switch the currently tuned channel to thepreviously tuned channel.Press CH RETURN again to restore the currently tunedchannel.Using 0 to 9 and • (dot) on the remote control unitSelect channels directly by pressing buttons 0 to 9. To selectsubchannels, also use the • (dot) button.EXAMPLE• To select channel 5 (one-digit channel), press 5.• To select channel 25 (two-digit channel), press 2 then 5.• To select channel 125 (three-digit channel), press 1, 2, then 5.• To select subchannel 10.01, press 1, 0, • (dot), 0, then 1.• To select subchannel 10.001 (for cable TV), press 1, 0,• (dot), 0, 0, then 1.Note• After entering a channel or subchannel number, you maypress CH ENTER to tune in the channel more quickly.• Each time you change a channel, a channel banner appearsthat shows information about the currently selected channel.To clear the channel banner, press INFO.• If you do not setup the TV Guide On Screen™ system, thechannel banner may not display certain types of programinformation.DTV 2 • 1002.102 A12:30pm — 2:00pmXXXXXXXXXX12:33pmXXXPlasma display (right side view)CHANNEL +/–Channel banner