27ENEnglishSystem SettingsAUDIOThis function allows you to switch the audio signal toautomatic or manual when inputting the digital signal.1 Press the MENU button to display the menu screen.STANDARD INPUT2PICTURE SCREEN SETUP OPTIONCONTRASTBRIGHTNESSCOLORTINTSHARPNESSMPEG NRDNRCTIMIDMIDONPICTURE RESETENTERSET EXITMENU: 0: 0: 0::::0: 02 Use the 2/3 buttons to select [SET UP].STANDARD INPUT2PICTURE SCREEN SETUP OPTIONPURECINEMACLAMP POSITIONSIGNAL FORMATCOLOR DECODINGHDMI INPUTBRT. ENHANCE ONOFFENTERSET EXITMENU:::::3 Use the 5/∞ buttons to select [HDMI INPUT], thenpress the SET button.STANDARD INPUT2PICTURE SCREEN SETUP OPTIONPURECINEMACLAMP POSITIONSIGNAL FORMATCOLOR DECODINGHDMI INPUTBRT. ENHANCE ONOFFENTERSET EXITMENU:::::4 Use the 5/∞ buttons to select [AUDIO].HDMI INPUTPICTURE SELECTAUDIOSETSET EXITMENU::AUTOAUTOSystem Settings5 Use the 2/3 buttons to select [AUDIO] setting.The unit has been factory set at the AUTO setting.Each time you press the 2/3 buttons, the settingchanges as follows:AUTO: Automatically identifies input audio signals.DIGITAL: Accept digital audio signals.ANALOG: Accept analog audio signals.NoteEven when AUTO is selected, automatic switching may notoccur properly with some input signals. In this event, selectDIGITAL or ANALOG manually in accordance with the actualsignal input.6 Press the SET button.This completes [AUDIO] setting, and returns you tothe display shown in step 3.7 After completing settings, press the MENU buttonto return to the normal display.Setting SR+MODE ModeSR+MODE setting is required when using the CONTROLOUT jack on the rear of this unit to connect anotherPioneer product (Refer to page 19 for connection details).1 Press the MENU button to display the menuscreen.STANDARD INPUT1PICTURE SCREEN SETUP OPTIONCONTRASTBRIGHTNESSCOLORTINTSHARPNESSMPEG NRDNRCTIMIDMIDONPICTURE RESETENTERSET EXITMENU: 0: 0: 0::::0: 0Display operating panel Remote control unitMENU2/35/∞SETMENU5/∞SET2/3AUTODIGITALANALOG
