23ENEnglishSystem SettingsSystem SettingsSettings After Connections(INPUT1, 2, 5)After components have been connected to INPUT1,INPUT2 or INPUT5, on-screen setup is necessary.Follow the procedure described below and make settingsas they apply to the type of components connected.Setting INPUT1 SELECTFor INPUT1 you can use D-sub INPUT and HDMI INPUT.Select the one you want to use.1 Press the MENU button to display the menuscreen.STANDARD INPUT1PICTURE SCREEN SETUP OPTIONCONTRASTBRIGHTNESSCOLORTINTSHARPNESSMPEG NRDNRCTIMIDMIDONPICTURE RESETENTERSET EXITMENU: 0: 0: 0::::0: 02 Use the 2/3 buttons to select [OPTION].STANDARD INPUT1::ENERGY SAVEPOWER MANAGEMENT:OFF:AUTO POWER OFF DISABLE:ORBITER OFF:MASK CONTROL ON:INPUT1 SELECT D-SUB:SR+ MODE OFFSTANDARDLANGUAGE ENGLISHENTERSET EXITMENUPICTURE SCREEN SETUP OPTION3 Use the 5/∞ buttons to select [INPUT1 SELECT],then press the SET button.STANDARD INPUT1PICTURE SCREEN SETUP OPTIONLANGUEGEENERGY SAVEPOWER MANAGEMENTAUTO POWER OFFORBITERMASK CONTROLINPUT1 SELECTSR+ MODE OFFONOFFDISABLEOFFSTANDARDENGLISHD-SUB::::::::4 Use the 2/3 buttons to select the desired INPUT.SETSET EXITMENUD-SUB:INPUT1 SELECTThe factory setting is [D-SUB]. Each time you press the2/3 buttons, the setting changes as follows:5 Press the SET button.This completes INPUT1 SELECT setting, and returnsyou to the display shown in step 3.[SIGNAL FORMAT] /[COLOR DECODING] setup(INPUT1 (D-SUB), 5)Notes÷ These settings are required (for INPUT1 (D-sub) or INPUT5)only when providing input signals with the following refreshrates: 1 31.5 kHz horizontal / 60 Hz; 2 45 kHz horizontal / 60Hz vertical; 3 48.4 kHz horizontal / 60 Hz vertical or 56.1 kHzhorizontal / 70 Hz vertical. Adjustment for other signalfrequency formats is performed automatically, so no manualsetting is required (Setting [SIGNAL FORMAT] is not possible).÷ The [COLOR DECODING] setting is not supported wheninputting a computer signal, or when the [SIGNAL FORMAT]function has been used to select a signal other than [480p] or[720p].÷ Perform [SIGNAL FORMAT] and [COLOR DECODING] settingsindividually for INPUT1 (D-sub) or INPUT5.3 D-SUB 23 HDMI 2Display operating panel Remote control unitMENU2/35/∞SETMENU5/∞SET2/3Display operating panel Remote control unitMENU2/35/∞SETMENU5/∞SET2/3
