85EnUse Other Equipment With Your Flat Panel TV 05In Video mode, the image is over-scanned (enlarged) but the panel automatically switches to PC when receivingcomputer signals. In PC mode, the image displays in full size for optimum image quality.5.2.2 Specify a Digital HDMI Signal TypeFor the necessary digital video signal type, check the operating manual that came with the other equipment.To assign the type of digital signal, follow the steps below.1 ) Access theOption through theSetup.2 ) SelectHDMI Input from the Option menu.3 ) SelectVideo from the submenu.4 ) Select the type of digital video signal recommended for the attached device.5 ) Press HOME MENU to exit the menu.If an image fails to appear, specify another digital video signal type. Type parameters other than Auto need to bechecked for natural colorings.5.2.3 Specify an Audio HDMI Signal TypeFor the necessary audio signal type, check the operating manual that came with the other equipment. Whenusing INPUT 4 or INPUT 5 for HDMI, select the terminal for the desired input source.To specify the audio type, follow the steps below.1 ) Access theOption through theSetup.2 ) SelectHDMI Input from the Option menu.3 ) SelectAudio from the submenu.4 ) Select the type of audio signal recommended for the attached device.5 ) Press HOME MENU to exit the menu.Type DescriptionAuto automatically identifies input digital signals(default)Color-1 Digital Component Video signals (4:2:2) lockedColor-2 Digital Component Video signals (4:4:4) lockedColor-3 Digital RGB signals (16 to 235) lockedColor-4 Digital RGB signals (0 to 255) lockedType DescriptionAuto automatically identifies input audio signals (default)Digital accepts digital audio signalsAnalog accepts analog audio signalsVideo (over-scan)PC (under-scan)
