11 Configure the settings relating to images andaudio [Image/Audio]The settings relating to JPEG and H.264 images such as the settings of image quality, audio, etc. can beconfigured on this page.The “Image/Audio” page has 3 tabs; the [JPEG/H.264] tab, the [Image quality] tab and the [Audio] tab.11.1 Configure the settings relating to the imagecapture mode [JPEG/H.264]Click the [JPEG/H.264] tab on the “Image/Audio” page. (®page 40, page 42)[Image capture mode]Select an image capture mode from the following.2 mega pixel [16:9]/1.3 mega pixel [16:9]/1.3 mega pixel [4:3]/3 mega pixel [4:3]• Default: 2 mega pixel [16:9]IMPORTANTThe positions of areas may move out of alignment when the “Image capture mode” setting is changedwhen the following area settings are configured. Therefore we recommend that you configure each areasetting after configuring the “Image capture mode”.– mask area (®page 91)– privacy zone (®page 98)– VMD area (®page 114)– VIQS area (®page 99)– Cropping outlines (®page 13)Note• The other i-PRO series products do not support the aspect ratio of “16:9” unless otherwise stated. (Asof December, 2011)• When “On” is selected for “VIQS” and the setting value for the aspect ratio is changed from “4:3” to“16:9”, make sure that the VIQS setting value does not exceed the maximum designated range.• When “3 mega pixel [4:3]” is selected, the following functions become unavailable.– “Image quality” for JPEG (the quality becomes “Quality1”)– H.264(2)– “Alarm image attachment” for mail notification– “Alarm image FTP transmission” for alarm– “FTP periodic image transmission” for periodic FTP transmission– “Cropping”– “Priority stream”Operating Instructions 7311 Configure the settings relating to images and audio [Image/Audio]
