11 Configure the settings relating to images andaudio [Image/Audio]The settings relating to JPEG and H.264 images such as the settings of image quality, audio, etc. can beconfigured on this page.The “Image/Audio” page has the [JPEG/H.264] tab, the [Image quality] tab and the [Audio] tab.11.1 Configure the settings relating to the imagecapture mode [JPEG/H.264]Click the [JPEG/H.264] tab on the “Image/Audio” page. (®page 40, page 42)[Image capture mode]Select an image capture mode from the following.2 mega pixel [16:9]/1.3 mega pixel [16:9]/1.3 mega pixel [4:3]/3 mega pixel [4:3]• Default: 2 mega pixel [16:9]IMPORTANT• The positions of areas may move out of alignment when the “Image capture mode” setting is changedwhen the following area settings are configured. Therefore we recommend that you configure eacharea setting after configuring the “Image capture mode”.– mask area (®page 92)– privacy zone (®page 97)– VMD area (®page 110)– VIQS area (®page 99)– Cropping outlines (®page 120)– Picture in picture cropping area (®page 121)Note• When “On” is selected for “VIQS” and the setting value for the aspect ratio is changed from “4:3” to“16:9”, make sure that the VIQS setting value does not exceed the maximum designated range.• When “3 mega pixel [4:3]” is selected, the following functions become unavailable.– “Pre alarm” for JPEG recording– “Image quality” for JPEG (the quality becomes “Quality1”)– H.264(2)– “Alarm image attachment” for E-mail notification– “Alarm image FTP transmission” for alarm– “FTP periodic image transmission” for periodic FTP transmission– “Cropping”– “Picture in picture”– “Priority stream”Operating Instructions 7511 Configure the settings relating to images and audio [Image/Audio]