Panasonic WV-NP1000 Operating Instructions Manual

Also see for WVNP1000 - NETWORK CAMERA: Integration note Network operating instructions Operating instructions Manual

Panasonic WV-NP1000 Operating Instructions Manual Manual pdf 13 page image

13How to use a varifocal lensBefore adjusting the varifocal lens, reset the back focal length position to the default position for the CS-mount (by simultane-ously pressing the [LEFT] and [RIGHT] buttons for 2 seconds or more, or by simultaneously pressing the [LEFT] and [RIGHT]buttons after pressing the [SET] button when the cursor is on "MANUAL-ADJ" on the "BACK-FOCUS SETUP" page.Method of adjustment may be different depending on the lens in use. For further information, refer to the operating instructionsof the lens in use.Notes:• The following are descriptions of how to adjust a normal varifocal lens. For further information, refer to the operatinginstructions of the lens in use.1. Focus on a subject which is located around 10 m away or farther to adjust the back focal length.2. When using an 8x or 10x varifocal lens, adjust the back focal length after setting the zoom to the WIDE end and set-tings the focus to the FAR end.When using a 2x or 3x varifocal lens, adjust the back focal length after setting the zoom to the TELE end and settingsthe focus to the FAR end.3. Locate a subject at the center and roughly adjust the angular field of view and the focus by adjusting the zoom positionand the focus position. Then, adjust the back focal length minutely. (→ page 17)• When the lens in use is not Panasonic's and whose focus range is scalable, adjust the back focal length after setting thefocus position to one step short of the FAR end in step 2. When adjusting the focus in the scalable range, focus may not beadjusted appropriately.How to use a fixed-focus lensWhen using a fixed-focus lens featured the focus adjustment, adjust the back focal length after setting the lens focus to theFAR end.When using a manual lensWhen using a manual lens, fit the provided connector cap into the ALC lens connector as shown in the illustrations below.(The tab of the connector cap should be toward the lens.)Manual lens Fitted connector capALC lens connectorConnector capTab