Panasonic WV-NP1000 Operating Instructions Manual

Also see for WVNP1000 - NETWORK CAMERA: Integration note Network operating instructions Operating instructions Manual

Panasonic WV-NP1000 Operating Instructions Manual Manual pdf 12 page image

12Lens MountingMount the lens by rotating it clockwise slowly. Then, connect the lens cable to the ALC lens connector of the camera.Optional lensLens type Model numberALC lens for 1/3 inch CCD cameras 2x varifocal (high resolution) WV-LZA62/2Other lenses for 1/3 inch CCD cameras can be mounted on this camera. However, high resolution scanning of this cameramay not be fully used for full-scanning (1280 x 960) or partial scanning (960 x 720).It is recommended to use a dedicated high-resolution lens when shooting a dark subject with the aperture opened.Focus adjustmentFocus adjustmentWhen shooting an object using an AF lens, the first adjusted focus may be out-of-focus depending on the focal depth of thelens in use. In this case, focus on a darker object with the aperture open to prevent out-of-focus.When "ABF" is selected for "BACK-FOCUS" on the SETUP menu (→ page 18), the camera can automatically focus on a subjectwith the best available conditions even when the illumination changes.• Under near-infrared light, the focus may be slightly out-of-focus than under visible light.When the "BACK-FOCUS SETUP" page is displayed and "AUTO" or "PRESET" is selected for "C/L ←→ B/W" using theoperation buttons on the camera, the camera can focus on subjects both under near-infrared light and under visible light.(However, the camera will not change the focus according to the illumination change when the focus had been adjustedonce.)PUSH TO LOCK/EJECTCS-mount lens (optional)ALC lens connectorAttach the ferrite core as close aspossible to the ALC lens connectorside of the lens cable.CS-mount: Less than 8 mmWithin φ 20 mm