27 Basic operationThe following are descriptions of how to configure each setup item using the operation buttons(refer to p. 10) on the camera. Setup using an optional system controller is also available.Notes:• The illustrations are the examples to be displayed on a video monitor.1. Hold down the [SET] button for around 2 sec-onds.→ The top page will be displayed.2. Move the cursor onto "END" by press the[UP] or [DOWN] button.3. Press the [SET] button after moving the cur-sor onto "SETUP" by pressing the [RIGHT]button.→ The "DISABLE" indication will change into"ENABLE" and the settings will becomeeditable.4. Move the cursor onto the desired setup itemand press the [SET] button.→ The setup page of the selected setup itemwill be displayed.5. Configure the settings for each item.Select setup item: Move the cursor bypressing the [UP] or [DOWN] button.Change the parameter: Press the [LEFT] or[RIGHT] button.Display the detailed settings page of thesetup item: Press the [SET] button whenthe setup item with the [O] mark isselected.Go back to the previous page: Move thecursor onto "RET" and press the [SET]button.Go back to the top page: Move the cursoronto "TOP" and press the [SET] button.MODEL WV-CW480 SERIESCAMERABACK-FOCUSSPECIALLANGUAGEEND SETUP DISABLEMODEL WV-CW480 SERIESCAMERABACK-FOCUSSPECIALLANGUAGEEND SETUP ENABLE**CAMERA SETUP** 1/2CAMERA ID OFFALC ALCSHUTTER OFFAGC ON(HIGH)SENS UP OFFSYNC INTWHITE BAL ATW1MOTION DET OFFDNR HIGHRESOLUTION HIGHBW MODE**CAMERA SETUP** 2/2PRIVACY ZONE OFFEL-ZOOM OFFUPSIDE-DOWN OFFSTABILIZER OFFLENS PANASONICRET TOP END