21C Electronic zoom setting [EL-ZOOM]Whether or not to use the electronic zoom is determined.ON: Uses the electronic zoom.OFF (default): Does not use the electronic zoom.When "ON" is selected, the zoom factor and the panning/tilting settings can be configured.Follow the procedure below.Step 1Move the cursor to "EL-ZOOM", select "ON" and press the [SET] button.→ The "EL-ZOOM" setting screen will be displayed.Step 2Move the cursor to "PUSH SET" of "ZOOM" and press the [SET] button.→ The zoom setting screen appears.Step 3Adjust the angular field of view by changing the electronic zoom factor (up to 2x) using the[UP]/ [DOWN] button, and press the [SET] button.Note:• When the zoom factor is incremented, resolution will be deteriorated.Step 4Move the cursor to "PUSH SET" of "PAN/TILT" and press the [SET] button.→ The pan/tilt setting screen appears.Step 5Use the [UP], [DOWN], [RIGHT], and [LEFT] buttons to determine the position of the area to beset and press the [SET] button.The position can be changed in the range of zoom factor set in the "ZOOM" setting screen.D Upside-down setting [UPSIDE-DOWN]ON: The video image can be reversed upside down.OFF (default): The video image cannot be reversed upside down.E Lens distortion correction [LDC]The image may be distorted depending on the lens used and the zoom factor. By adjusting the lens dis-tortion correction setting, the distorted image can be converted to match the square monitor and achieveeffects desired by the user.** EL-ZOOM ** ** EL-ZOOM **PUSH SETPUSH SET** EL-ZOOM **PUSH SETPUSH SET PUSH SETPUSH SETZOOMPAN/TILT ZOOMPAN/TILTZOOMPAN/TILTU ZOOM D L PAN R"SYSTEM SETUP" screen “EL-ZOOM” setting screenRET TOP END RET TOP END“ZOOM” setting screen “PAN/TILT” setting screenRET TOP ENDMANUALSYNCPRIVACY ZONESTABILIZEREL-ZOOMUPSIDE-DOWNOFFINTOFFONOFFI...... 0- +LDCFOCUS**SYSTEM SETUP**RET TOP ENDU TILT D /