Panasonic WJ-NX400K Installation Manual

Also see for WJ-NX400K: Operating instructions Important information Installation guide Important information Operating instructions

Panasonic WJ-NX400K Installation Manual Manual pdf 36 page image

36Step 6Enter a user name and a password to register for a camerawith "*" in the results.Step 7Click the [Next] button.→ IP address will be given to the cameras newly con-nected, replaced or added, and the images from thecamera will be displayed on the operational screen.Note:• On "Easy Start", it is impossible to register the camera ina different network via the same router.• For the security enhancement, changing of the IPaddress of the camera will become impossible when 20minutes have passed after the power is turned on.Perform the camera detection within 20 minutes, or turnoff the power of the camera and turn it on again if morethan 20 minutes has passed. Refer to the operatinginstructions of the camera for further information.When 20 minutes have passed after the power of thecamera is turned on, "ONVIF" may be detected depend-ing on the models of Panasonic cameras. In such acase, turn off the power of the camera and turn if onagain to perform the camera detection.• When "On" is selected for the "DHCP" setting of thedetected cameras, the recorder will forcibly change thesetting to "Off" to give the IP addresses automatically.• When the [Cancel] button is clicked, the top screen of"Easy Start" (the menu to set the date & time) withoutapplying the camera detection result will be displayed.Step 8When you wish to change the registered camera numbers,it is possible to change the order of the camera numbers.Images from the cameras will be displayed on the monitorfrom the upper left corner to the right in order of the cameranumber (1, 2 ... 64).To interchange camera numbers, drag the camera image tobe moved with the mouse and drop on the desired position.If the camera titles are to be interchanged as well, mark the"Also change camera titles" checkbox.[New] buttonUsually use it with no camera registered in the recorder.Detects all the connected cameras.The models and results of the detected cameras will be displayed.Make sure that the model numbers of all the connectedcameras are being displayed.[Addition] buttonUsually use it when there are added or replaced camerasduring operation.Detects only the added or replaced cameras.The models and results of the detected cameras will be displayed.Make sure that the model numbers of all the added orreplaced cameras are being displayed.Important:• When there are cameras in use, the system can overwritethe registered information and assign new IP addressesto all connected cameras (including cameras currently inuse) by clicking the [New] button.• Cameras newly added after the operation start will beregistered in the default settings. To conform the set-tings to those of the registered cameras, perform thesettings for the added cameras.• For the video encoder (WJ-GXE500), only the cameraconnected to CH1 will be detected. The channels CH2to CH4 are needs to be registered from the setup menu.[Camera]After the license is registered (☞ page 29), 64, 96 or 128cameras can be connected.[Model]When Panasonic cameras are used, the model numbers willbe displayed.[Results]New: Displayed when the camera is newly connected tothe recorder.Replaced: Displayed when the camera has beenreplaced by another one.Added: Displayed when the camera connection is addedto the recorder.Registered: Displayed when the camera has alreadybeen registered.Lost: Displayed when the registered camera is notdetected.Blank: No camera is detected.*: Administrator not registeredNote:• If "Lost" is displayed or the column is left blank, check ifthe power of the camera is turned on, and make surethat cables are properly connected.8 Configure the minimum settings [Easy Start] (continued)