18 Connection for emergency recordingWhen the external switch is turned ON, emergency recording will be started.Recording time and recording rate for emergency recording differ according to the settings of "Emergency REC" on the setupmenu. (Refer to the setup instructions (PDF) for further information about the setup menu.) Connection for external recording changeoverWhen the external switch is turned ON, the program changeover is affected for recording.The program can be set by selecting "EXT" for "Time Table" of "Schedule" on the setup menu. (Refer to the setup instructions(PDF) for further information about the setup menu.) Connection for the Auto Adjust Time function• When "Auto Adjust Time" of "Time & Date" of "System" on the setup menu is set to "MASTER""Time Adjust Output" becomes available and the clock of this unit can be applied to other units.The time adjust output signal will be supplied from pin no.20 to other unit at the time set for "Time & Date" ("System" – "Time &Date" – "Time & Date").Terminal block of other unit(Time adjust output)(Earth)ALARM/CONTROL(Earth)Sensor inputAlarm inputAlarm reset inputSeries recording inputTime adjust input(Earth)Alarm outputAlarm reset outputAlarm recordingDuring recordingDiskBuzzer outputSystem error outputThermal error outputTime adjust outputSeries recording output!3 @0Front LEDmonitoroutputALARM/CONTROL(Earth)(Emergency recording input)External switch!3 !2External switchALARM/CONTROL(Earth)!3 @4(External recording mode input)

Limitation of Liability

Important Safety Instructions

Precautions

Preface

About these Operating Instructions

Major Operating Controls and Their Functions

rear view

Rack Mounting

Connection

Connection between cameras and PCs

I How to Use the Terminals of the ALARM/CONTROL Connector

I How to Use the Terminals of the ALARM Connector

Turn On/Off the Power of the Unit

Check the IP Address

How to Replace the Hard Disks

Troubleshooting

Specifications

Panasonic WJ-ND200 Installation Manual

WJND200 - NETWORK DISK RECORDER

operating instructions

Trademarks and Registered Trademarks

Recording/Playback/Live Image Transmission

Restrictions when operating MPEG-4 images

Operational Mode

Switch the operational mode from the mirroring mode to the single mode

Hard Disk Drive Management

Format (initialize) the hard disk drive in the single mode)

Recording

Playback

Start playback from a designated time and date

Search and Play Recorded Event

How to Operate

Monitor Live Images

Display Images from Cameras on a 4-Screen

Display Images in the Sequential Display

Control Cameras

Zoom/Focus/Brightness Operations

Move a Camera to the Preset Position

About the Event Function

Cancel the Alarm Action

Cancel the Error Status

Hard Disk Manually

Display/Edit the Text Information

Transmits Camera Images onto an FTP Server

Check Logs

Check the Access Log

Check the Event Log

Check the Network Log

Obtain Images on an SD memory card

Download Recorded Images

Play Downloaded Images

Install the Viewer Software

Uninstalling the Viewer Software

Save Downloaded Images

Print the Displayed Image

Perform the Alteration Detection

Notification by E-Mail

About the Error Log

When the Error Log is Displayed

Precaution

System Requirements for a PC

Start/Exit the Software

Main Window

Icons in the Tree Display Area

Operation Flow

Detect WJ-ND300 (A)/Cameras and Confirm the Current Settings

Arrange the Camera Number by Moving/Deleting the Camera Icon

Delete a camera icon

Edit the Settings

Register the WJ-ND300 (A) and Cameras, and Confirm the Result CAM IP Auto Addressing)

Register the WJ-ND300 (A) and Cameras, and Confirm the Result Manual Registration)

Panasonic WJ-ND200 Installation Manual

Product

Learn More

Legal