Panasonic WJ-ND200 Installation Manual

Also see for WJND200 - NETWORK DISK RECORDER: Brochure Reference Operating instructions Operating instructions Operating instructions

Contents

Panasonic WJ-ND200 Installation Manual Manual pdf 12 page image

12q Network portConnect this unit to a network compatible with 10BASE-T or 100BASE-Tx to connect a PC/cameras via a net-work.w Alarm connector (ALARM, D-sub 25-pin, Female)Connect an external device such as a sensor or a doorswitch with this D-sub 25-pin connector.e Alarm/Control connector (ALARM/CONTROL, D-sub25-pin)Connect a control switch with this D-sub 25-pin connec-tor when controlling this unit using an external device,or when controlling an alarm device such as a buzzeror a lamp.r Signal ground terminal (SIGNAL GND)t Power switch (POWER)y Power cord inlet (AC IN)Connect the power cord to this inlet.After connecting the power cord, fix the power cordusing the provided brace as follows.1. Attach the provided brace to the rear panel of theunit.2. Fix the power cord using the brace as shown in theillustration below.ONOFFPOWERALARMALARM/CONTROLSIGNAL GND10/100BASE-TAC INq wtrye Rear ViewBrace (standard accessory)