Panasonic WJ-HD88 Operating Instructions Manual

Also see for WJ-HD88: Brochure & specs Network operating instructions

Panasonic WJ-HD88 Operating Instructions Manual Manual pdf 29 page image

29(3) Move the cursor to "PTZ SELECT" and press the [SET]button.Move the cursor to the desired channel by using thedirection buttons (up/down). Select the channel byusing the direction buttons (right/left).In the above figure, "Cam1" is selected in the "PTZSELECT" menu. No other camera are selected in otherchannels.(4) Press the [MENU] button. "WJ-HD88 SETUP MENU"appears. Refer to step (1).(5) Move the cursor to "CAMERA SETUP" and press the[SET] button.The "CAMERA SETUP" menu appears. Select "PTZProtocol".When using the Panasonic’s camera, select "PANA-SONIC" using the direction buttons (left/right).In other cases, refer to the relevant instruction manualfor that camera.(6) Press the [MENU] button. "WJ-HD88 SETUP MENU"appears. Refer to step (1).(7) Move the cursor to "COMMUNICATION SETUP" andpress the [SET] button. Then move the cursor to "RS485SETUP" and press the [SET] button.Note: When the Panasonic's camera is used, make set-tings of the respective parameters according to theabove-mentioned procedures. In other cases, referto the relevant operating instructions.Caution: In order to maintain normal communicationbetween this unit and the cameras, it is necessaryto have completely correct settings for "PTZSELECT", "PTZ Protocol", and "RS485 SETUP".The camera control mode comes in three types.Each time the [SET] button is pressed in the state ofmonitoring, the mode changes. The related icon isdisplayed in a lower area of the screen.• Pan/tilt control mode• Zoom/focus mode• Iris control modeNote: For some types of cameras, some controlsmany not function. Refer to the relevant operat-ing instructions of the camera and confirmwhether this unit is enabled to support controlsand connections.2.5.1 Panning/Tilting(1) Select the desired channel by using the direction buttonor numeric button. The image frame of the selectedchannel blinks.Select the pan/tilt control mode by pressing the [SET]button once.The camera pan/tilt control icon is displayed on thescreen of the selected channel.(2) Press the direction button and turn the camera in theproper direction.Note:In the pan/tilt control mode, two external units canbe connected to the cameras.When the camera select button [1] is pressed,External Unit 1 is set to ON.When the camera select button [2] is pressed,External Unit 2 is set to ON.When the camera select button [6] is pressed,External Unit 1 is set to OFF.When the camera select button [7] is pressed,External Unit 2 is set to OFF.(3) Press the [SET] button 3 times to close the pan/tilt con-trol mode.2.5.2 Auto function (Auto Pan, etc.)(1) Select the pan/tilt control mode by pressing the [SET]button once.The camera pan/tilt control icon is displayed on thescreen of the selected channel.(2) Start the auto function by pressing the [PLAY] button.Note: Refer to the Operating Instructions of the camerafor descriptions of the auto function.OKCam1Cam5Cam2Cam6Cam3Cam7Cam4Cam8PTZ SELECTCancelCAMERA SETUP1Channel No.OnCH EnableSetMask AreaOffMask EnablePANASONICPTZ Protocol000All OK CancelRec. ReserveChannel Name CH1DaysRS485 SETUPOK19200Baud RateCancel8Data BitNoneParity1Stop Bit